Installation Instructions

ManualsBrandsSub-Zero ManualsAccessoriesStainless Steel Flush Inset Freezer Door Panel with Pro Handle

Metal Front Panels

7004566 / Rev A / February, 2008

Page 1 of 4

CONT

AINS:

QTY

DESCRIPTION

1 Panel

1 Bag of Front Panel Clips

1 Instruction Sheet

FRONT P

ANEL

CLIP INSTALLATION PROCEDURE:

Insert the clips into the rectangular holes in the rear flanges of the front panel as shown in Figure 1, making sure

the 1/4” (6 mm) wide part of the clips is facing toward the outer edge of the panel as this will slide under the door

trim.

PANEL

(REAR VIEW)

PANEL CLIP

Figure 1. Front Panel Clip Installation

NOTE: The clip installation is the same regardless of the panel.

(Over/under Refrigerator door panel shown)

Summary of content (4 pages)

PAGE 1
Metal Front Panels CONTAINS: QTY 1 1 1 DESCRIPTION Panel Bag of Front Panel Clips Instruction Sheet FRONT PANEL CLIP INSTALLATION PROCEDURE: Insert the clips into the rectangular holes in the rear flanges of the front panel as shown in Figure 1, making sure the 1/4” (6 mm) wide part of the clips is facing toward the outer edge of the panel as this will slide under the door trim. PANEL CLIP L NE EW) A I P V AR E R ( PANEL CLIP Figure 1.
PAGE 2
Metal Front Panels DOOR HANDLE-SIDE TRIM REMOVAL PROCEDURE: HANDLE-SIDE TRIM OR HANDLE-SIDE TRIM DO SCREW COVER 1. At the top of the door, insert a flat blade screwdriver into the channel of the screw cover and push the cover away form the handle-side trim so that it disengages from the handle-side trim (See Figure 2). 2. With a T-20, 6-lobe Torx type bit, extract the handle-side mounting screws and pull the trim from the door (See Figure 3). Figure 3. Handle-Side Trim Removal Figure 2.
PAGE 3
Metal Front Panels OVER/UNDER MODEL FREEZER DRAWER TOP TRIM REMOVAL PROCEDURE: 1. At the back right-hand side of the top drawer trim (or handle-side trim), insert a flat blade screwdriver into the notch in the screw cover and pry the cover away form the top trim, disengaging it from the top trim (See Figure 5). 2. With a T-20, 6-lobe Torx type bit, extract the top trim mounting screws and pull the top trim from the drawer (See Figure 6).
PAGE 4
Metal Front Panels BOTTOM GRILLE FRAME EXTRUSION REMOVAL PROCEDURE (See Figure 8): Use a T-20, 6-lobe Torx type bit to extract the two lower grille frame extrusion mounting screws from each side of the grille and pull the bottom grille extrusion along with the corner brackets from the side grille extrusions. PANEL GRILLE FRAME ASSEMBLY SCREWS (2 OF 4) BOTTOM GRILLE FRAME EXTRUSION Figure 8. Bottom Frame Extrusion Removal GRILLE PANEL INSTALLATION PROCEDURE (See Figure 9): 1.