design guide

subzero.com/specs | 21
BUILT-IN REFRIGERATION
Custom Panels
FLUSH INSET PANELS
The ush inset application is an overlay model with ush
inset panels. It is not a separate model.
The ush inset design allows custom panels to be installed
ush with adjacent cabinets. Similar to overlay, ush inset
panels are typically created by combining a
3
/4" (19) custom
panel, a .10"
(3) spacer panel, and a
1
/4" (6) backer panel.
Refer to the illustrations for overlay panels.
For ush inset panels thicker than
3
/4" (19), a 90° door stop
may be required to prevent interference with adjacent
cabinets. Refer to the full-scale templates at the end of this
guide.
When installing two units side by side, refer to page 17 for
dual ush inset installations.
ICE AND WATER DISPENSER
For models BI-42SD and BI-48SD, the refrigerator door
panel must include a cutout to accommodate the external
dispenser. The bezel will accommodate a
1
/4" (6) thick panel
for framed applications and a
3
/4" (19) thick panel for overlay
and ush inset applications. Panels thicker than
3
/4" (19)
must be routed in the dispenser area to 1
1
/8" (29) (including
backer and spacer panels).
6
1
/4" (159)
1
/4"
(6)
12
7
/8"
(327)
Dispenser dimensions
BUILT-IN PRO 48 INTEGRATED WINE UNDERCOUNTER