design guide

20 | Sub-Zero Customer Care 800.222.7820
BUILT-IN REFRIGERATION
PANEL MOUNTING KIT
The Sub-Zero custom panel mounting kit eliminates the need
for the backer and spacer panels and is avail able through an
authorized Sub-Zero dealer. For local dealer information, visit
the nd a showroom section of our website, subzero.com.
The kit consists of mounting cleats, screws, and gages used
to properly position the cleats. The kit is available for all
built-in models except glass door models. Dual installations
require two mounting kits.
OVERLAY PANELS
Overlay panels are typically created by combining a
3
/4" (19)
custom panel, a .10"
(3) spacer panel, and a
1
/4" (6) backer
panel. Refer to the illustrations below.
When installing two units side by side, refer to page 16 for
dual standard installations.
1
/8" (3) (OVERLAY)
CUSTOM PANEL
SPACER PANEL
BACKER PANEL
TRIM
5
/16" (8) min
1
/4" (6)
.10" (3)
CUSTOM
PANEL
SPACER
PANEL
BACKER
PANEL
3
/4"
(19)
typical
Panel assembly (cross section) Panel assembly (rear view)
Custom Panels
PARTIAL FRAMED OPTION
The partial framed kit includes a stainless steel panel for
above and below the external dispenser. Refer to the chart
below for panel width. The kit is avail able through an autho-
rized Sub-Zero dealer. For local dealer information, visit the
nd a showroom section of our website, subzero.com.
PARTIAL FRAMED PANEL
W
BI-42SD 15
1
/16" (383)
BI-48SD 18
3
/4" (476)
UNDERCOUNTER WINE INTEGRATED PRO 48 BUILT-IN