design guide

52 | Sub-Zero Customer Care 800.222.7820
INTEGRATED REFRIGERATION
Custom Panels
For integrated models, custom door panels and handle
hardware must be provided. Refer to the Panel Require-
ments chart and Typical Panel Dimensions.
The thickness of the custom panel can vary. A minimum
5
/8" (16) thick panel is required, but the thickness can be
increased provided it does not exceed the weight limit. The
depth of each integrated model is 24"
(610). Allow for panel
thickness when planning the nished opening depth. Refer
to the full-scale template on page 55.
CAUTION
As reveals between cabinetry and the unit decrease,
severe nger pinching can occur while the door is
closing.
Finish all sides of the custom panels. They will be visible
when the door/drawer is open.
D-style handles are recommended. Locate the door handle
near the edge of the panel opposite the hinge and centered
top to bottom. Locate drawer handles near the top edge
of each panel. Stainless steel tubular and pro handles are
avail able through an authorized Sub-Zero dealer. For local
dealer information, visit the nd a showroom section of our
website, subzero.com.
PANEL REQUIREMENTS
WEIGHT PER PANEL MAX
18" Column 45 lb (20 kg)
24" Column 60 lb (27 kg)
30" Column 75 lb (34 kg)
36" Column 75 lb (34 kg)
WEIGHT PER PANEL MAX
30" Tall (door) 50 lb (22 kg)
36" Tall (door) 60 lb (27 kg)
Drawer 15 lb (7 kg)
PANEL THICKNESS MIN
All Panels
5
/8" (16)
UNDERCOUNTER WINE INTEGRATED PRO 48 BUILT-IN
Stainless Steel Panels
The outdoor model requires the use of Sub-Zero stainless
steel outdoor accessory panels. Stainless steel panels are
available through an authorized Sub-Zero dealer. For local
dealer information, visit the nd a showroom section of our
website, subzero.com.
The thickness of indoor stainless steel panels is
3
/4" (19) and
outdoor stainless steel panels are 1
1
/2" (38). The depth of
each integrated model is 24"
(610). Allow for panel thickness
when planning the nished opening depth.
Reveals of
1
/8" (3) are typical, however, the reveal between
the upper and lower outdoor stainless steel panel is
1
/4" (6)
to accommodate the lock.