Design Guide

subzero.com | 15
FRAMED PANELS
The framed application is an overlay model with framed
design features. It is not a separate model.
If the custom panel is thinner than ⁄"
(6), a filler material
must be added to achieve a proper fit. If the panel is thicker
than ⁄"
(6), rout an edge around the panel or mount the
custom panel on a sheet of ⁄"
(6) thick material and insert
into the channel. Refer to the illustrations below.
Routing, recessing, or optional extended handles may be
required for finger clearance. Refer to the full-scale tem-
plate on page 30.
When installing two units side by side, refer to page 12 for
dual standard installations.
Custom Panels
For all models excluding stainless steel, door panels and
handles must be provided. Refer to Panel Requirements
below and the charts on pages 18–23 for custom panel
dimensions for your specific design application.
IMPORTANT NOTE: Do not cover a glass door with a solid
panel.
Finish all sides of the custom panels. They may be visible
when the door is open or through the window of glass
door models.
PANEL REQUIREMENTS
WEIGHT PER PANEL MAX
BI-36R, BI-36RG, BI-36F 75 lb (34 kg)
All Other Models 50 lb (23 kg)
Grille Panel 13 lb (6 kg)
PANEL THICKNESS MIN
Framed ⁄" (6)
Overlay and Flush Inset ⁄" (16)
DOOR
1
/4" ( 6) TRIM REVEAL
1
/4" ( 6) PANEL
1
/4" ( 6) min
ROUT TO
1
/4" ( 6)
DOOR
Panel ⁄" thick or less
Panel thicker than ⁄"
Classic Series Refrigeration