Sub-Zero Connect Guide

Appliances that contain the radio module are required to be marked in an
area easily accessible by an end user as follows:
This device contains the WLAN / Bluetooth radio:
FCC ID: MHI-CONAPPWM
IC: 3681C-CONAPPWM
MODEL: CONAPPWM
A user guide with required Regulatory verbiage below (FCC statement and IC notice) for the Federal
Communication Commission and Industry Canada must be made readily available to the end user
either in hard-copy or electronic form. The usage of the FCC logo either on the label (for larger
devices) or in the user documentation (in this case and typical of physically small transceivers) is
required and governed by FCC usage guidelines. Usage of the logo constitutes a declaration of
conformity (DoC) to the FCC rules and regulations.
FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee the
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to consult an authorized dealer or service representative for
help. Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. Information on this equipment including data relative to maximum permissible RF
exposure is on file with the FCC and can be found at https://www.fcc.gov/oet/ea/fccid after
searching on the FCC ID for this equipment listed on the product labeling.
RESPONSIBLE PARTY:
Sub-Zero Inc.
4717 Hammersley Road
Madison, WI 53711
Phone [phone]
INDUSTRY CANADA NOTICE FOR CONNECTED APPLIANCES
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Ce dispositif est conforme à la norme CNR-210 d’Industrie Canada applicable aux appareils radio
exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne
doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y
compris un brouillage susceptible de provoquer un fonctionnement indésirable.