Design Guide

16 | Sub-Zero Customer Care 800.222.7820
PANEL MOUNTING KIT
The Sub-Zero custom panel mounting kit eliminates the
need for the backer and spacer panels and is avail able
through an authorized Sub-Zero dealer. For local dealer
information, visit the find a showroom section of our
website, subzero.com. The kit consists of mounting cleats,
screws, and gages used to properly position the cleats.
The kit is available for all Classic models except glass door
models. Dual installations require two mounting kits.
OVERLAY PANELS
Overlay panels are typically created by combining a ⁄"
(19)
custom panel, a .10" (3) spacer panel, and a ⁄"
(6) backer
panel. Refer to the illustration below.
When installing two units side by side, refer to page 12 for
dual standard installations.
1
/4" (6)
.10" (3)
CUSTOM
PANEL
SPACER
PANEL
BACKER
PANEL
3
/4"
(19)
typical
Panel assembly (rear view)
Custom Panels
PARTIAL FRAMED OPTION
The partial framed kit includes a stainless steel panel for
above and below the external dispenser. Refer to the chart
below for panel width. The kit is avail able through an
authorized Sub-Zero dealer. For local dealer information,
visit the find a showroom section of our website, subzero.
com.
PARTIAL FRAMED PANEL W
BI-42SD 15⁄" (383)
BI-48SD 18⁄" (476)
Classic Refrigeration