Design Guide

20 | Sub-Zero Customer Care 800.222.7820
CLASSIC REFRIGERATION
PANEL MOUNTING KIT
The Sub-Zero custom panel mounting kit eliminates the need
for the backer and spacer panels and is avail able through an
authorized Sub-Zero dealer. For local dealer information, visit
the nd a showroom section of our website, subzero.com.
The kit consists of mounting cleats, screws, and gages used
to properly position the cleats. The kit is available for all
Classic models except glass door models. Dual installations
require two mounting kits.
OVERLAY PANELS
Overlay panels are typically created by combining a
3
/4" (19)
custom panel, a .10"
(3) spacer panel, and a
1
/4" (6) backer
panel. Refer to the illustrations below.
When installing two units side by side, refer to page 16 for
dual standard installations.
1
/8" (3) (OVERLAY)
CUSTOM PANEL
SPACER PANEL
BACKER PANEL
TRIM
5
/16" (8) min
1
/4" (6)
.10" (3)
CUSTOM
PANEL
SPACER
PANEL
BACKER
PANEL
3
/4"
(19)
typical
Panel assembly (cross section) Panel assembly (rear view)
Custom Panels
PARTIAL FRAMED OPTION
The partial framed kit includes a stainless steel panel for
above and below the external dispenser. Refer to the chart
below for panel width. The kit is avail able through an autho-
rized Sub-Zero dealer. For local dealer information, visit the
nd a showroom section of our website, subzero.com.
PARTIAL FRAMED PANEL
W
BI-42SD 15
1
/16" (383)
BI-48SD 18
3
/4" (476)