Built-In Extended Height Grille Installation Guide

6
|
Sub-Zero Customer Care 800.222.7820
EXTENDED HEIGHT GRILLE
Grille Hinging System
HINGING SYSTEM
Specify the customer-supplied hinging system consistent
with cabinetry and with sufcient capacity to support the
weight of the decorative grille panel. Refer to the illustration
below.
IMPORTANT NOTE: If refrigeration components must be
removed for service, the standard grille frame will need to be
removed rst for sufcient access to the machine compart-
ment. To avoid an unsupported load, the decorative panel
will need to be removed from the cabinetry rst.
CLEAT
Field install a cleat to the back side of the decorative grille
panel to hold the ip-up inner grille frame in position when
raised. Follow dimensions in the inset illustration below for
the 10"
(254) long cleat. For location of the cleat, also refer to
the illustration on the following page. For a dual installation,
use two cleats.
CAUTION
The cleat must include a lip as shown, to prevent unin-
tentional separation of the decorative panel and grill
frame.
HINGING FOR
DECORATIVE
GRILLE PANEL
STANDARD GRILLE
FRAME IN CLOSED
POSITION
HINGING FOR
DECORATIVE
GRILLE PANEL
STANDARD GRILLE
FRAME IN FULLY
RAISED POSITION
GRILLE CLEARANCE
REQUIRED FOR SERVICE
CLEAT
CLEAT END VIEW
1
/2" (13)
2" (51)
1
1
/2"
(38)
1
/
2
"
(13) LIP
2" (51)
1
1
/
2
"
(38)
Grille hinging system (side view).