DESIGN & INSTALLATION GUIDE Extended Height Grille for Built-In
Extended Height Grille 2 Extended Height Grille IMPORTANT NOTE: Throughout this guide, dimensions in This design feature involves potentially hazardous elements consisting of large, heavy panels located overhead. It is the responsibility of the designer to specify panel support components suitable for this use and the installer to use proper workmanship during construction. Sub-Zero cannot be liable for custom applications beyond its control.
Extended Height Grille 3 subzero.com/specs Built-In Design FLUSH INSET FLUSH INSET PANELS To blend in more seamlessly with surrounding cabinetry, panels can be flush inset. This design option allows for custom grille and door panels to be completely flush with surrounding cabinetry.
Extended Height Grille 4 Air Flow Requirements AIR FLOW AIR FLOW SIDE VIEW AIR FLOW ABOVE MOLDING CABINETRY 1/2" (13) MIN SPACE ALL SIDES FRONT VIEW Allow for at least 1/2" (13) space on all four sides of the grille panel for proper air flow to the refrigeration system. For flush inset models, this is around the sides, top and bottom of the decorative grille panel. SIDE VIEW Space must be maintained between decorative grille panel and surrounding cabinetry for air flow.
Extended Height Grille 5 subzero.com/specs Air Flow Requirements INSTALL PANEL FUNCTIONAL PANEL SIDE VIEW A 1/4" (6) thick functional panel must be installed in the inner grille frame (the part that flips up) to prevent warm air discharge from short-circuiting back into the system. Use sizing for the ‘backer panel’ found in the panel configurator or Sub-Zero design guide.
Extended Height Grille 6 Grille Hinging System HINGING SYSTEM—INSTALL CLEAT HINGING FOR DECORATIVE GRILLE PANEL HINGING FOR DECORATIVE GRILLE PANEL 11/2" (38) 1/2" (13) LIP 2" (51) CLEAT END VIEW GRILLE CLEARANCE REQUIRED FOR SERVICE CLEAT STANDARD GRILLE FRAME IN CLOSED POSITION STANDARD GRILLE FRAME IN FULLY RAISED POSITION SIDE VIEW Specify the customer-supplied hinging system consistent with cabinetry and with sufficient capacity for the weight of the decorative grille panel.
Extended Height Grille 7 subzero.com/specs Grille Hinging System INSTALL CLEAT AND CATCH INSTALL CATCH C L 2 1/2" (64) MIN CLEAT 3" (76) DECORATIVE GRILLE PANEL (FRONT VIEW) CATCH 2 1/2" (64) MIN CLEARANCE HOLE CATCH INNER GRILLE FRAME AND FUNCTIONAL PANEL (FRONT VIEW) The cleat must be located to the left of a line 3" (76) to the right of the center of the built-in unit, to clear the system fan shroud.
SUB-ZERO, INC. P. O. BOX 44848 MADISON, WI 53744 8 / 2014 SUBZERO.COM 800.222.
