Use and Care Guide

subzero.com | 11
CONDENSER
CAUTION
Before cleaning the condenser, turn power o at the
control panel. Wear gloves to avoid injury from sharp
condenser fins.
The condenser is located behind the flip-up grille. Clean
the condenser every 6–12 months.
To clean the condenser:
1 Turn power o at the control panel.
2 Pull out on the bottom edge of the grille and rotate
upward. Refer to the illustration below.
3 Use a soft bristle brush and vacuum to remove dust and
lint from the condenser. To avoid damaging condenser
fins, vacuum in the direction of the fins.
CAUTION
Failure to clean the condenser could result in tem-
perature loss, mechanical failure, or damage.
Care Recommendations
Condenser location
CONDENSER
Cleaning
STAINLESS STEEL EXTERIOR
Use a nonabrasive stainless steel cleaner and apply with a
soft lint-free cloth. To bring out the natural luster, lightly
wipe the surface with a water-dampened microfiber cloth
followed by a dry polishing chamois. Always follow the
grain of stainless steel.
INTERIOR CLEANING
To clean interior surfaces and all removable parts, wash
with a mild solution of soap, water, and baking soda. Rinse
and dry thoroughly. Avoid getting water on the lights, con-
trol panel, and cherrywood facing on wine racks.
Use a standard glass cleaner to clean the UV-resistant glass
door.
CAUTION
Do not use vinegar, rubbing alcohol, or other
alcohol-based cleaners on any interior surface.