User Guide

18
WOLF DUAL FUEL RANGES
VERIFY RANGE OPERATION
IMPORTANT NOTE: Prior to operating the
range, be sure to read the entire Wolf Dual
F
uel Ranges Use & Care Information included
with the range for important safety, service
and warranty information.
Install the oven rack guides onto the shoulder
s
crews located on the interior side walls of the
oven. Slide the oven racks onto the support
racks within the oven. There are three racks
per oven, except for the 18" (457) oven which
has two racks. Place the broiler pan and grid
on a rack within the oven, if desired.
Turn on the power supply to the range. The
control panel should be closed (no visible
control pads). Touch and slightly depress the
flame graphic on the hidden control panel to
open.
Set the time of day by pressing the
CLOCK
touch pad, scroll to the desired time by using
the up or down arrows, then touch
ENTER .
After setting the time, the hidden control panel
can be closed. The control panel does not have
to be open to operate the oven.
Select any of the eight cooking modes by
using the oven control knob bezel and turning
to the desired mode. Once the mode has been
selected, the temperature can be adjusted by
turning the temperature readout knob clock-
wise to increase the temperature or counter-
clockwise to decrease the temperature. Verify
that the oven is coming up to temperature. For
a 48" (1219) or 60" (1524) range, follow this
procedure for the both ovens.
IMPOR
T
ANT NOTE:
A small amount of
smoke and odor may be noticed during the
initial break-in period. Refer to the Use & Care
Infor
mation for additional infor
mation.
REMOVING THE RANGE
If removing the dual fuel range is necessary for
cleaning or service, shut off the gas supply.
D
isconnect the gas supply and electrical
connections to the unit, then remove the
range. Reinstall in the reverse order and be
s
ure to check the gas connection for leaks.
R
efer the Wolf Dual Fuel Ranges Use & Care
Information included with the range for
cleaning recommendations.
Be sure to disconnect the gas supply and
electrical connections before removing
the range.