F RYER M ODULE I NSTALLATION I NSTRUCTIONS
C O N TA C T I N F O R M AT I O N Wolf Customer Service: 800-332-9513 Website: wolfappliance.com As you follow these instructions, you will notice WARNING and CAUTION symbols. This blocked information is important for the safe and efficient installation of Wolf equipment. There are two types of potential hazards that may occur during installation. signals a situation where minor injury or product damage may occur if you do not follow instructions.
W O L F F RY E R M O D U L E I N S TA L L AT I O N R E Q U I R E M E N T S B E F O R E YO U S TA RT IMPORTANT NOTE: Save these Installation Instructions for the local inspector’s use. IMPORTANT NOTE: Installation and service must be performed by a qualified installer or service agency. Warranty service must be performed by a Wolf authorized service center. Please read the entire Installation Instructions prior to installation. This installation must be completed by a qualified technician.
W O L F F RY E R M O D U L E S I T E P R E PA R AT I O N IMPORTANT NOTE: Installation of the Wolf electric fryer module must meet the following location requirements. All dimensions listed are minimum requirements for safe operation. Refer to the illustration below. To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above the surface units should be avoided.
I N S TA L L AT I O N I N S T R U C T I O N S I N S TA L L AT I O N S P E C I F I C A T I O N S The illustrations below provide the overall dimensions, finished cut-out dimensions and electrical placement for the Wolf electric fryer module. MODEL IF15/S DIMENSIONS The fryer module is designed to fit a standard 24" (610) deep base cabinet with 25" (635) deep countertop. Before making the countertop cutout, verify that the module will clear the side walls of the base cabinet below.
W O L F F RY E R M O D U L E M A N UA L D R A I N O U T L E T IMPORTANT NOTE: The fryer module must be installed in a base cabinet that allows access to the manual drain valve for draining the oil. A heat-resistant bucket must be positioned under the drain outlet to accept the oil. The bucket must be able to hold 2 gallons (7.6 L). Refer to the Installation Specifications illustration on page 5 for location of the manual drain outlet.
I N S TA L L AT I O N I N S T R U C T I O N S V E N T I L AT I O N O P T I O N S IMPORTANT NOTE: It is recommended that you operate the Wolf electric fryer module with either a Wolf cooktop or Pro ventilation hood or hood liner. Contact your Wolf dealer for details. Cooktop Wall Hood – 30" (762) or 36" (914) widths in classic stainless steel. Cooktop Island Hood – 42" (1067) width in classic stainless steel.
W O L F F RY E R M O D U L E ELECTRICAL R E Q U I R E M E N T S Verify that power is disconnected from the junction box before proceeding. Required Power Supply 240 V AC, 60 Hz, 15 amp service 208 V AC, 60 Hz, 15 amp service Maximum Connected Load 2.6 kW at 240 V AC 1.9 kW at 208 V AC The Wolf electric fryer module requires a separate, grounded 3-wire 240/208 V AC, 60 Hz, 15 amp service with its own circuit breaker. The module is provided with a 4' (1.
I N S TA L L AT I O N I N S T R U C T I O N S M O D U L E I N S TA L L AT I O N B E F O R E O P E R AT I N G Attach the foam strip to the underside of the module frame. Refer to the illustration below. Read the entire Wolf Fryer Module Use & Care Information included with the module. Important safety, service and warranty information is contained within the book. Gently lower the fryer module into the cut-out area in the countertop and center.
W O L F F RY E R M O D U L E M O D U L E R E M OVA L TROUBLES H O OT I N G IMPORTANT NOTE: Removal of the fryer module should only be performed by a Wolf authorized service center technician. IMPORTANT NOTE: If the fryer module does not operate properly, follow these troubleshooting steps: If removing the fryer module is necessary for cleaning or service, first disconnect the electric supply. Remove the mounting brackets on each side of module and remove. To reinstall, refer to page 9.
I N S TA L L AT I O N I N S T R U C T I O N S I F Y O U N E E D S E RV I C E If service is necessary, maintain the quality built into your electric fryer module by calling a Wolf authorized service center. To obtain the name and number of a Wolf authorized service center, check the Locator section of our website, wolfappliance.com or call Wolf Customer Service at 800-332-9513. When calling for service, refer to the model and serial number of the fryer module.
W O L F A P P L I A N C E C O M PA N Y, L L C 807562 6 / 2006 P. O. B OX 4 4 8 4 8 MADISON, WI 53744 800-332-9513 W O L FA P P L I A N C E .
