User Guide

6
When two or more modules are installed
together, an integrated module filler strip
(
IFILLER/S) is recommended. Contact your
Wolf dealer for information on accessories.
IMPORTANT NOTE: Review specific
installation instructions for product to product
c
apabilities.
WOLF FRYER MODULE
MANUAL DRAIN OUTLET
IMPORTANT NOTE: The fryer module must be
installed in a base cabinet that allows access to
t
he manual drain valve for draining the oil. A
heat-resistant bucket must be positioned under
the drain outlet to accept the oil. The bucket
m
ust be able to hold 2 gallons (7.6 L). Refer to
the Installation Specifications illustration on
page 5 for location of the manual drain outlet.
MULTIPLE COOKTOP INSTALLATION
IMPORTANT NOTE: If the fryer module is to
be used with a combination of additional
cooktop units or modules with a filler strip, the
cut-out width is calculated by adding the corre-
sponding units' cut-out dimensions plus 1
1
/4"
(32) for each additional unit.
When multiple units are installed side by side,
each unit must have its own separate recom-
mended electrical circuit.
2
1
/2"min
(64)
FRONT OF COUNTERTOP
19
1
/4"
(489)
CUT-OUT
DEPTH
29
1
/4" (743)
TWO MODULES WIDTH
44
1
/2" (1130) THREE MODULES WIDTH OR
44
1
/4" (1124) 30" COOKTOP AND ONE MODULE
59
3
/4" (1518) FOUR MODULES WIDTH OR
59
1
/2" (1511) 30" COOKTOP AND TWO MODULES OR
50
1
/4" (1276) 36" COOKTOP AND ONE MODULE
14"
(356)
CUT-OUT
WIDTH
Countertop cut-out dimensions for installation of multiple cooktops
This fryer module must be installed at
least 15" (381) away from any open-flame
cooking device. The open flame may
cause ignition of oil.
This fryer module must be installed at
least 15" (381) away fr
om a Wolf steamer
module, as contact between water and
hot oil may cause burns from steam and
hot oil.