User Guide

CARE RECOMMENDATIONS
COMPONENT CARE RECOMMENDATION
27
WOLF GAS RANGE CARE
SIGNATURE
POLISH
Signature Polish
is available from
Signature Limited
Laboratory,
P.O. Box 13436,
Dayton, Ohio
45413-0436, or
call 877-376-5474
(toll free).
Do not use abrasive cleaners; they will permanently scratch the surface.
Salt and some cooking liquids may pit and stain the surface. Always remove
these spills immediately. Use a spray degreaser to remove fingerprints and
g
reasy spatters. Spray on a cloth and wipe surface. Buff dry immediately to
avoid streaking. For hard water stains, use white vinegar and water.
Exterior Cleaning: Use a soft, nonabrasive stainless steel cleaner like
Signature Polish (see side note) and apply with a soft lint-free cloth. To bring
out the natural luster
, lightly wipe the surface with a water-dampened
microfiber cloth, followed with a dry microfiber cloth. All work should follow
the grain direction of the finish. Better results are obtained by keeping the
cloth in continuous contact with the metal.
Allow burner base and cap to cool first. Wash in warm water and liquid
detergent. Rinse and dry.
Spray degreasers and mild abrasive cleaners may be used.
Caution! Do not use abrasive cleaners (e.g. Comet); they will perma-
nently scratch the surface.
Salt and some cooking liquids may pit and stain the surface. Always remove
these spills immediately. For general care, use a clean cloth or sponge; wipe
with warm water and a mild dish detergent. Rinse and dry immediately. Use
a spray degreaser to remove fingerprints and greasy spatters. Spray on a
cloth and wipe surface. Buff dry immediately to avoid streaking. For hard
water stains, use white vinegar and water
.
Remove fr
om gas range top and place on a flat surface near the sink.
Nonabrasive cleaners to use include: Hot water and liquid detergent, paste of
baking soda and water, plastic pad or sponge.
Spray degreasers and mild abrasive cleaners may be used.
W
ipe with damp cloth and mild soap and water; rinse and dr
y
.
Never soak
or use abrasive cleaners; they will scratch the finish and remove the
markings.
Use a spray degr
easer to r
emove fingerprints
and food soils. Spray first on a
cloth before wiping panel.
Do not spray directly on panel around valve
stems.
Exterior Finish
Bull-Nose Riser
Stainless steel
Burner Base
and Cap
Porcelain enamel
(matte finish)
and brass
Drip Pan
Porcelain enamel
(glossy finish
on steel)
Bur
ner Grates
Porcelain-coated,
cast iron
Control Knobs
Plastic
(red or black)
Contr
ol Panel
Stainless steel
Dimensions in parentheses are in
millimeters unless other
wise specified.