Design Guide

72 | Sub-Zero Customer Care 800.222.7820
Custom Panel—UW-24
For model UW-24, the custom door panel will attach
directly to the door frame with screws through a series of
pre-drilled holes.
Refer to the charts below for panel requirements and
dimensions.
PANEL REQUIREMENTS
WEIGHT PER PANEL MAX
UW-24 10 lb (5 kg)
PANEL THICKNESS MIN
UW-24 ⁄" (16)
OVERLAY PANEL DIMENSIONS
H
W
AA
A
A
Custom Panels
For framed, overlay, Designer, and flush inset applications,
a custom door panel must be provided. Handle hardware
must also be provided for overlay, Designer, and flush inset
applications. Refer to the panel requirements and custom
panel dimensions charts for your specific model and
design application.
Do not install a solid panel on a glass door unit. A solid
door is available as a sales accessory (except model
BW-30) and must be installed if a solid panel is being spec-
ified. Service may be required to install the door. Contact
an authorized Sub-Zero dealer for more information. Over-
all dimensions are the same for glass and solid door panels.
Finish all sides of the custom panels. They may be visible
when the door is open or through the window of glass
door models.
Model UW-24FS has a finished stainless steel exterior that
is designed to be used in a freestanding application.
UW-24
PANEL DIMENSIONS
PANEL W H
UW-24 23⁄" (603) 30⁄" (764)
STILES / RAILS A
Minimum 2⁄" (57)
DOOR CLEARANCE
Model UW-24 can be installed flush with surrounding
cabinetry. Depending on the thickness of the overlay door
panel, it may be necessary to install the unit ⁄"
(6) beyond
the front surface of adjacent cabinetry to prevent interfer-
ence when the door is opened to 145°. Refer to the full-
scale template on page 83.
Wine Storage