Design Guide

54 | Sub-Zero Customer Care 800.222.7820
Custom Panels
For Designer series models, custom door panels and
handle hardware must be provided. Refer to the Panel
Requirements chart and Typical Panel Dimensions.
The thickness of the custom panel can vary. A minimum
⁄"
(16) thick panel is required, but the thickness can be
increased provided it does not exceed the weight limit. The
depth of each Designer series model is 24"
(610). Allow for
panel thickness when planning the finished opening depth.
Refer to the full-scale template on page 57.
CAUTION
As reveals between cabinetry and the unit decrease,
severe finger pinching can occur while the door is
closing.
Finish all sides of the custom panels. They will be visible
when the door/drawer is open.
D-style handles are recommended. Locate the door handle
near the edge of the panel opposite the hinge and cen-
tered top to bottom. Locate drawer handles near the top
edge of each panel. Stainless steel tubular and pro handles
are avail able through an authorized Sub-Zero dealer. For
local dealer information, visit the find a showroom section
of our website, subzero.com.
PANEL REQUIREMENTS
WEIGHT PER PANEL MAX
18" Column 45 lb (20 kg)
24" Column 60 lb (27 kg)
30" Column 75 lb (34 kg)
36" Column 75 lb (34 kg)
WEIGHT PER PANEL MAX
30" Tall (door) 50 lb (22 kg)
36" Tall (door) 60 lb (27 kg)
Drawer 15 lb (7 kg)
PANEL THICKNESS MIN
All Panels ⁄" (16)
Stainless Steel Panels
The outdoor model requires the use of Sub-Zero stainless
steel outdoor accessory panels. Stainless steel panels are
available through an authorized Sub-Zero dealer. For local
dealer information, visit the find a showroom section of
our website, subzero.com.
The thickness of indoor stainless steel panels is ⁄"
(19)
and outdoor stainless steel panels are 1⁄"
(38). The depth
of each Designer series model is 24"
(610). Allow for panel
thickness when planning the finished opening depth.
Reveals of ⁄"
(3) are typical, however, the reveal between
the upper and lower outdoor stainless steel panel is ⁄"
(6)
to accommodate the lock.
Designer Series Refrigeration