I NDUCTION C OOKTOP I NSTALLATION I NSTRUCTIONS
As you follow these instructions, you will notice WARNING and CAUTION symbols. This blocked information is important for the safe and efficient installation of Wolf equipment. There are two types of potential hazards that may occur during installation. signals a situation where minor injury or product damage may occur if you do not follow instructions. states a hazard that may cause serious injury or death if precautions are not followed.
W O L F I N D U C T I O N C O O K TO P I N S TA L L AT I O N R E Q U I R E M E N T S IMPORTANT NOTE: Save these Installation Instructions for the local inspector’s use. Please read the entire Installation Instructions prior to installation. This installation must be completed by a qualified technician. Installer: please retain these instructions for local inspector’s reference, then leave them with the homeowner.
W O L F I N D U C T I O N C O O K TO P S I T E P R E PA R AT I O N IMPORTANT NOTE: Installation of the Wolf induction cooktop must meet the following location requirements. All dimensions listed are minimum requirements for safe operation. To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above the surface units should be avoided.
I N S TA L L AT I O N I N S T R U C T I O N S I N S TA L L AT I O N S P E C I F I C A T I O N S The illustrations below provide the overall dimensions, finished cut-out dimensions and electrical placement for the Wolf induction cooktop. MODEL CT15I/S DIMENSIONS When the cooktop is installed above cabinets, the electrical placement is not critical. A grounded junction box needs to be placed within 4' (1.2 m) of the right rear of the cooktop.
W O L F I N D U C T I O N C O O K TO P I N S TA L L AT I O N S P E C I F I C A T I O N S C O U N T E R T O P C U T- O U T M U LT I P L E C O O K T O P I N S T A L L AT I O N The induction cooktop is designed to fit a standard 24" (610) deep base cabinet with 25" (635) deep countertop. Before making the cooktop cut-out, verify that the cooktop will clear the side walls of the base cabinet below.
I N S TA L L AT I O N I N S T R U C T I O N S V E N T I L AT I O N O P T I O N S IMPORTANT NOTE: It is recommended that you operate the Wolf induction cooktop with either a Wolf cooktop hood, downdraft system or Pro ventilation hood. Contact your Wolf dealer for details. Cooktop Wall Hood – 30" (762) or 36" (914) widths in classic stainless steel. Cooktop Island Hood – 42" (1067) width in classic stainless steel.
W O L F I N D U C T I O N C O O K TO P ELECTRICAL R E Q U I R E M E N T S Verify that power is disconnected from the junction box before proceeding. Required Power Supply 240 V AC / 18 amp / 60 Hz – 20 amp service The cooktop is provided with a 4' (1.2 m) conduit consisting of two insulated hot lead conductors (copper) and one insulated ground conductor (copper).
I N S TA L L AT I O N I N S T R U C T I O N S C O O K T O P I N S TA L L AT I O N B E F O R E O P E R AT I N G T H E C O O K T O P L O C AT I N G U N I T I N C O U N T E R T O P Clean the glass surface carefully using Cooktop Cleaning Crème provided with the product. Remove all cleaner residues. Attach the foam strip to the underside of the cooktop frame. Refer to the illustration below. Gently lower the unit into the cut-out area in the countertop and center.
W O L F I N D U C T I O N C O O K TO P CLEANING A N D MAINTENANCE TROUBLES H O OT I N G TO R E M OV E T H E C O O K TO P I F C O O K T O P D O E S N O T O P E R AT E IMPORTANT NOTE: This procedure should only be performed by a Wolf Factory Authorized Service Center technician. IMPORTANT NOTE: If the cooktop does not operate properly, follow these troubleshooting steps: If removing the cooktop is necessary for cleaning or maintenance, disconnect the electric supply.
I N S TA L L AT I O N I N S T R U C T I O N S I F Y O U N E E D S E RV I C E Maintain the quality built into your induction cooktop by calling a Wolf Factory Authorized Service Center. To obtain the name and number of a Wolf Factory Authorized Service Center, call Wolf Customer Service at 800-332-9513 or check our website, wolfappliance.com. When calling for service, you will need the cooktop model and serial numbers.
W O L F A P P L I A N C E C O M PA N Y, L L C 8 0 6 7 4 8 R E V- A 4/ 2005 P. O. B OX 4 4 8 4 8 MADISON, WI 53744 800-332-9513 W O L FA P P L I A N C E .
