User Guide

4
LOCATION IN COUNTERTOP
A
)
M
inimum flat countertop surface. Must be
equal to or greater than cooktop width.
B) Minimum 2" (51) wide clearance from the
cooktop side edge to any combustible
surface up to 18" (457) above the cooktop
(noted by shaded area).
C) Minimum 2" (51) wide clearance from the
cooktop side edge to any combustible
surface up to 18" (457) above the cooktop
(noted by shaded area).
OVERHEAD CABINET DIMENSIONS
D) Minimum spacing between cabinets directly
over cooktop must be greater than or equal
to the nominal width of the cooktop unit(s).
E) Minimum 18" (457) vertical distance from
the countertop surface to the bottom of
cabinets adjacent to the cabinet directly
above the cooktop unit.
F) Minimum 24" (610) clearance between top
of cooking surface and bottom of wood or
metal cabinet which is protected by not less
than 1/4" (6) flame retardant millboard
covered with not less than No. 28 MSG
sheet steel, .015" (.4) stainless steel, or .024"
(.6) aluminum or .02" (.5) copper. Minimum
30" (762) clearance between the top of the
cooking surface and the bottom of an
unpr
otected wood or metal cabinet.
G) Minimum 0" (0) from rear wall.
H) Maximum 13" (330) depth of overhead
cabinets.
SITE PREPARATION
IMPORTANT NOTE: Installation of the Wolf
induction cooktop must meet the following
l
ocation requirements. All dimensions listed
are minimum requirements for safe operation.
To eliminate the risk of burns or fire by
reaching over heated surface units,
c
abinet storage space located above the
surface units should be avoided. If
cabinet storage is to be provided, the risk
can be reduced by installing a ventilation
hood that pr
otects horizontally a
minimum of 5" (127) beyond the bottom
of the cabinets.
Failure to locate the cooktop unit
without the pr
oper clearances will r
esult
in a fire hazard.
WOLF INDUCTION COOKTOP
D
H
E
A
B
C
F
G
Minimum clearances for installation