User Guide

10
WOLF SEALED BURNER RANGETOP
INSTALL THE RANGETOP
Prepare the finished rough opening for the
rangetop according to the Installation Specifi-
c
ations illustration for your model on pages
7–9. The platform must be
3
/4" (19) thick and
include a cut-out at the right rear for gas
s
upply and electrical connections.
I
MPORTANT NOTE:
T
he platform must be
level to ensure that the cooking surface is
level.
Remove and discard all packing materials,
including cardboard and tape on the outside of
the rangetop. Remove the burner grates and
styrofoam off the top cooking surface. Be
sure to remove the burner caps packaged in
styrofoam below the burner grates.
If your installation requires a riser, it must be
attached to the rangetop before installation.
Refer to the installation instructions packaged
with the riser.
Position the rangetop on the platform. Gas
supply and electrical connections should be
made before the rangetop is placed in its final
position.
GAS SUPPLY REQUIREMENTS
EXPLOSION HAZARD—
Use a certified gas supply line and install
a gas shut-off valve.
Securely tighten all gas connections.
The maximum gas supply pressure to the
r
egulator should never exceed 14" (34.9
mb) WC (water column); .5 psi (3.5 kPa).
Failure to do so can result in explosion,
fire or death.
TYPES OF GAS
There are two types of gas, natural and liquid
propane (LP). Conversions are required in
order for appliances designed for one gas to be
operated with the other gas. Such conversions
must be performed by a Wolf authorized
service center. Make sure your Wolf sealed
burner rangetop is correctly adjusted for the
type of gas being used.
The product rating plate has information on
the type of gas that should be used. The rating
plate is located under the control panel on
the far right. Refer to the illustration on page 3.
If this information does not agree with the
type of gas available, contact your Wolf
dealer. To obtain local dealer information,
visit the Locator section of our website,
wolfappliance.com.
Wolf sealed burner rangetops using natural gas
will operate up to an altitude of 8,000' (2438 m)
without any adjustment. Natural gas and LP
gas installations from 8,000' (2438 m) to
11,000' (3353 m) need the high altitude conver
-
sion kit. Contact your Wolf dealer for details.