Design Guide

66 | Sub-Zero Customer Care 800.222.7820
WINE STORAGE
Custom Panels—427G and 427RG
For models 427G and 427RG, the custom door panel will
attach directly to the door with screws through a series
of pre-drilled holes. For model 427RG, the drawer panels
will attach using mounting brackets supplied with the unit.
Refer to the panel requirements chart and integrated panel
dimensions.
The thickness of the custom panel can vary. A minimum
5
/8" (16) thick panel is required, but the thickness can be
increased provided it does not exceed the weight limit. The
depth of each model is 24"
(610). Allow for panel thickness
when planning the nished opening depth.
CAUTION
When using a
3
/4" (19) or thicker panel with a reveal less
than
1
/4" (6), panel may cause damage to the unit when
door is opened to 105°. Use the built-in 90° door stop.
CAUTION
As reveals between cabinetry and the unit decrease,
severe nger pinching can occur while door is closing.
PANEL REQUIREMENTS
PANEL WEIGHT MAX
Door 20 lb (9 kg)
Drawer (427RG) 12 lb (5 kg)
PANEL THICKNESS MIN
All Panels
5
/8" (16)
Finish all sides of custom panels. They will be visible when
the door/drawer is open.
D-style handles are recommended. Door handles must be
located near the edge of the panel opposite the hinge and
should be centered top to bottom. Drawer handles must
be located near the top edge of each panel. Stainless steel
tubular and pro handles are avail able through an authorized
Sub-Zero dealer. For local dealer information, visit the nd a
showroom section of our website, subzero.com.
An optional lock kit is available for models 427G and
427RG. Review the lock kit instructions to ensure your
panels will allow for adequate installation. These instructions
are available on our website, subzero.com/specs.
INTEGRATEDUNDERCOUNTER PRO 48 BUILT-INWINE