EH025/035取説_米国向EU1717 02.5.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ02 WARNING : The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. NOTICE FEDERAL EMISSION COMPONENT DEFECT WARRANTY and CALIFORNIA EMISSION CONTROL WARRANTY are applicable to only those engines complied with EPA (Environmental Protection Agency) and CARB (California Air Resources Board) emission regulations in the U.S.A.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ03 FEDERAL EMISSION COMPONENT DEFECT WARRANTY EMISSION COMPONENT DEFECT WARRANTY COVERAGE This emission warranty is applicable in all States, except the State of California. Fuji Heavy Industries Ltd. and Robin America Inc.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ04 *Consequential damages such as loss of time, inconvenience, loss of use of the engine of equipment, etc. *Diagnosis and inspection charges that do not result in warranty-eligible service being performed. *Any non-authorized replacement part, or malfunction of authorized parts due to use of non-authorized parts.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ05 CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The California Air Resources Board and Fuji Heavy Industries Ltd. are pleased to explain the emission control system warranty on your 2000 and later Small Off-Road engine(herein "engine"). In California, the engines must be designed, built and equipped to meet the State's stringent anti-smog standards. Fuji Heavy Industries Ltd.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ06 LIMITED WARRANTY on Emission Control Systems - California Only Fuji Heavy Industries Ltd.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ07 (2) improper installation, adjustment or repair of the engine or of any warranted part unless performed by an authorized dealer. (3) failure to follow recommendations on fuel use contained in the 2000 and later Owner's Manual. (4) repairs performed outside of the authorized warranty service facility. (5) use of parts, which are not authorized by Fuji Heavy Industries Ltd.. 2.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ08 (2) Ignition System (i) Spark plug (ii) Flywheel magneto (iii) Ignition coil (3) Miscellaneous Items Used in Above Systems (i) Hoses and sealing gaskets, bolts, connectors, and assemblies. I.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ09 FOREWORD Thank you very much for purchasing a ROBIN ENGINE. Your ROBIN ENGINE can supply the power to operate various sorts of machines and equipment. Please take a moment to familiarize yourself with the proper operation and maintenance procedures in order to maximize the safe and efficient use of this product. Due to constant efforts to improve our products, certain procedures and specifications are subjected to change without notice.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ010 CONTENTS 1. SAFETY PRECAUTIONS ・・・・・・・・・・・・・・・・・・・・・・・・・・・・1 2. COMPONENTS ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・4 3. PRE-OPERATION CHECKS ・・・・・・・・・・・・・・・・・・・・・・・・・・6 4. OPERATING YOUR ENGINE ・・・・・・・・・・・・・・・・・・・・・・・・・7 5. EASY TROUBLESHOOTING ・・・・・・・・・・・・・・・・・・・・・・・・・9 6. MAINTENANCE SCHEDULE ・・・・・・・・・・・・・・・・・・・・・・・・・11 7. "HOW-TO" MAINTENANCE ・・・・・・・・・・・・・・・・・・・・・・・・・・13 8. PREPARATIONS FOR STORAGE・・・・・・・・・・・・・・・・・・・・・17 9.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ011 SYMBOLS Read the owner's manual. Stay clear of the hot surface. Exhaust gas is poisonous. Do not operate in an unventilated area. Stop the engine before refueling. Fire, open flame and smoking prohibited.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ1 1. SAFETY PRECAUTIONS Please make sure you review each precaution carefully. EXHAUST PRECAUTIONS NNever inhale exhaust gasses. They contain carbon monoxide, a colorless, odorless and extremely dangerous gas which can cause unconsciousness or death. Never operate the engine indoors or in a poorly ventilated area, such as tunnel, cave, etc. Exercise extreme care when operating the engine near people or animals. Keep the exhaust pipe free of foreign objects.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ2 PROTECTIVE COVER Place the protective covers over the rotating parts. If rotating parts such as the drive shaft, pulley, belt, etc. are left exposed, they are potentially hazardous. To prevent injury, equip them with protective covers or shrouds. Be careful of hot parts. The muffler and other engine parts become very hot while the engine is running or just after it has stopped. Operate the engine in a safe area and keep children away from the running engine.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ3 Drain the fuel when transporting the engine. Do not move the engine while in operation when it has been removed from the equipment. Keep the unit dry (do not operate it in rainy conditions). PRE-OPERATION CHECKS. Carefully check fuel hoses and joints for looseness and fuel leakage. Leaked fuel creates a potentially dangerous situation. Check bolts and nuts for looseness. A loose bolt or nut may cause serious engine trouble.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ4 2. COMPONENTS EH025 Plug cover Air cleaner Stop switch Clutch Fuel tank cap Fuel tank Choke lever Muffler Carburetor Primer pump Oil gauge (Oil filler) Starter handle Recoil starter Engine serial No.
EH025/035取説_米国向EU1717 02.5.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ6 3. PRE-OPERATION CHECKS CHECK ENGINE OIL Before checking or refilling engine oil, be sure the engine is located on a stable, level surface and stopped. ;; ; ; ;; Do not thread the gauge into oil filler to check oil level. If the oil level is below the lower level line on the dipstick, refill with the proper oil (see table) up to the upper level (up to the point of overflowing the filler neck).
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ7 4. OPERATING YOUR ENGINE STARTING PRIMER PUMP STOP SWITCH 3 1 ON ON OFF Set the throttle lever to the idling position. If the stop switch is installed on the engine.Set the stop switch to the position "ON or I ". Push the primer pump 7 to 10 times to feed the fuel to the carburetor. If the stop switch is installed on a machine side.Set the stop switch to the position "ON or I ".
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ8 STOPPING STOP SWITCH CHOKE LEVER 1 5 ON OFF OFF Set the throttle lever at the low speed position and allow the engine to run at low speed for 2 or 3 minutes before stopping. If the stop switch is installed on the engine.Set the stop switch to the position "OFF or O ". After starting the engine, gradually open choke by turning the choke lever and finally keep it fully opened. If the stop switch is installed on a machine side.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ9 5. EASY TROUBLESHOOTING WHEN ENGINE DOES NOT START: Perform the following checks before you take the engine to your Robin dealer. If you still have trouble after completing the checks, take the engine to your nearest Robin dealer. Is the engine switch set ON? Is there enough compression? 1. Pull the starter handle slowly and check if resistance is felt. 2. If little force is required to pull the starter handle, check if the spark plug is tightened firmly. 3.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ10 Is there a strong spark across the electrode? WARNING Wipe out spilled fuel carefully before checking. Place spark plug as far away from spark plug hole as possible. Do not hold spark plug by hand while checking. 1. Remove the spark plug and connect it to the plug cap. Pull the starter handle while grounding spark plug against engine body using an insulated pliers. 2. Try with a new spark plug if the spark is weak or there is no spark. 3.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ11 6. MAINTENANCE SCHEDULE DAILY INSPECTION Before running the engine, check the following service items. PERIODIC MAINTENANCE Periodic maintenance is vital to safe and efficient operation of your engine. Check the table below for periodic maintenance intervals. IT IS ALSO NECESSARY FOR THE USER OF THIS ENGINE TO CONDUCT THE MAINTENANCE AND ADJUSTMENTS ON THE EMISSION-RELATED PARTS LISTED BELOW TO KEEP THE EMISSION CONTROL SYSTEM EFFECTIVE.
EH025/035取説_米国向EU1717 02.5.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ13 7. "HOW-TO" MAINTENANCE INSPECTING THE SPARK PLUG Clean off carbon deposits on the spark plug electrode using a plug cleaner or wire brush. Check electrode gap. Adjust gap 0.7 mm to 0.8 mm (0.03 inches) 0.7 to 0.8 mm (0.03 in.) Use a proper spark plug : NGK CMR6A ENGINE OIL CHANGE Initial oil change After 20 hours of operation Thereafter Every 50 hours of operation Refer to the recommended oil table on page 5. Always use the best grade and clean oil.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ14 3) Remove the oil gauge, then tilt the engine and drain the oil into a pan or other receptacle. 4) Put the engine on a level surface, then fill with the oil up to the point of overflowing the filler neck. Pour the oil in from a squeeze bottle or other appropriate. 5) After filling the engine with oil, reinsert the oil gauge. Ensure that the oil gauge is tight, as if it loosens later oil will leak out.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ15 CLEANING FUEL FILTER Remove the hose clamp and pull out the fuel filter from fuel pipe. Wash the fuel filter with kerosene. After washing, reassemble it. If the fuel filter is heavy dirty, replace it with new one. CLEANING AIR CLEANER Dirty air cleaner element will cause starting difficulty, power loss, engine malfunctions, and shorten engine life extremely. Keep the air cleaner element clean. Remove the fixing bolt of air cleaner cover.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ16 CHECKING BOLTS, NUTS AND SCREWS Retighten loose bolts and nuts. Check for fuel and oil leaks. Replace damaged parts with new ones. Keep safety in your mind. FUEL PIPE REPLACEMENT Replace the fuel pipe every 1 year. If the fuel leakage is found on the fuel pipe, replace it immediately.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ17 8. PREPARATIONS FOR STORAGE DISCHARGE FUEL (NO SMOKING !) In case the engine is not going to be used for more than one month, discharge fuel thoroughly from fuel tank and carburetor in order to prevent from hard starting and/or poor engine operation due to deteriorated fuel when you use the engine next time. Pour out the fuel in the tank from its filler neck. Push the primer pump of the carburetor until the fuel in it is thoroughly discharged.
EH025/035取説_米国向EU1717 02.5.15 11:39 AM ページ18 9. SPECIFICATIONS MODEL Type EH025A EH035A Air-Cooled, 4-Stroke, Single Cylinder, Overhead valve, Gasoline Engine Bore x Stroke 1.34 in. x 1.06 in. (34 mm x 27 mm) 1.54 in. x 1.10 in. (39 mm x 28 mm) Displacement 1.49 cu. in. (24.5 cm3) 2.04 cu. in. (33.5 cm3) 0.81kW (1.1 HP) / 7000 rpm 1.18kW (1.6 HP) / 7000 rpm Maximum Output Maximum Torque Direction of Rotation Lubricant Capacity of Lubricant 1.18 N m (0.12 kgf m)/ 5000 rpm 1.76 N m (0.
EH025/035取説_米国向EU1717 02.5.
EH025/035取説_米国向EU1717 02.5.