MODEL EX30D 2ZZ9990095
WARNING: The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. NOTICE FEDERAL EMISSION COMPONENT DEFECT WARRANTY and CALIFORNIA EMISSION CONTROL WARRANTY are applicable to only those engines complied with EPA (Environmental Protection Agency) and CARB (California Air Resources Board) emission regulations in the U.S.A. JP US GB DE NOTICE To the engines exported to and used in the countries other than the U.S.A.
FEDERAL EMISSIONS COMPONENT DEFECT WARRANTY EMISSIONS COMPONENT DEFECT WARRANTY COVERAGE This emission warranty is applicable in all States, except the State of California. Fuji Heavy Industries Ltd. and Robin America Inc., Wood Dale Illinois, (herein “ROBIN AMERICA”) warrant(s) to the initial retail purchaser and each subsequent owner, that this Nonroad engine (herein “engine”) has been designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U.S.
CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The California Air Resources Board and Fuji Heavy Industries Ltd. (herein “FUJI”) are pleased to explain the emission control system warranty on your 2005 and later Small Off-Road engine (herein "engine"). In California, new engine must be designed, built and equipped to meet the State's stringent anti-smog standards.
When warranty repair is needed, the engine must be brought to an authorized service dealer or warranty station’s place of business during normal business hours. In all cases, a reasonable time, not to exceed 30 days, must be allowed for the warranty repair to be completed after the engine is received by the authorized service dealer or warranty station. G.
FOREWORD Thank you very much for purchasing a ROBIN ENGINE. Your ROBIN ENGINE can supply the power to operate various sorts of machines and equipment. Please take a moment to familiarize yourself with the proper operation and maintenance procedures in order to maximize the safe and efficient use of this product. Keep this owner’s manual at hand, so that you can refer to it at any time.
1. SAFETY PRECAUTIONS Please make sure you review each precaution carefully. Pay special attention to statement preceded by the following words. WARNING “WARNING” indicates a strong possibility of severe personal injury or loss of life if instructions are not followed. CAUTION “CAUTION” indicates a possibility of personal injury or equipment damage if instructions are not followed. WARNING : EXHAUST PRECAUTIONS ■ Never inhale exhaust gasses.
■ Do not touch the spark plug and ignition cable when starting and operating the engine. ■ Never make adjustments on the machinery while it is connected to the engine, without first removing the ignition cable from the spark plug. Turning the crankshaft by hand during adjusting or cleaning might start the engine, and cause serious injury to the operator. ■ Operate the engine on a stable, level surface. If the engine is tilted, fuel spillage may result.
SYMBOLS Read the owner's manual. Stay clear of the hot surface. Exhaust gas is poisonous. Do not operate in an unventilated area. JP Stop the engine before refueling. US GB DE Fire, open flame and smoking prohibited. FR NL ES On (Run) Plus ; Positive polarity Off (Stop) Battery Engine oil Engine start (Electric start) IT PT GR NO SE Add oil FI DK RU CN 2. COMPONENTS (See Fig. 1) AR NOTE Please refer to the illustrations on the back page of the front cover or back cover for Fig.
3. PRE-OPERATION CHECKS 4. ELECTRIC STARTER MODELS For electric starter operation, proper electric wiring NOTE Engine shipped from our factory is without oil. Before starting engine, fill with oil. Do not over-fill. arrangements are needed before normal engine operation. 1. BATTERY ■ Use a battery rated 12V-24AH or larger. CHECK ENGINE OIL (See Fig. 2) Before checking or refilling engine oil, be sure the engine is WARNING ■ Charge the battery in a fully ventilated location.
5. OPERATING YOUR ENGINE 4. WIRING (See Fig. 3) MAGNETIC SWITCH CABLE 1. STARTING To KEY SWITCH (TERMINAL "ST") (1) Open the fuel cock. (2) Turn the STOP SWITCH to the position “ I ” (ON). (See Fig.3-q) EARTH WIRE (3) Close the choke lever. (See Fig.3-w) ■ If the engine is cold or the ambient temperature is low, close the choke lever fully. ■ If the engine is warm or the ambient temperature is high, open the choke lever half-way, or keep it fully open.
2. PERIODIC INSPECTION ※ STOPPING ENGINE WITH THE FUEL COCK Close the fuel cock and wait for a while until the engine stops. Avoid to let the fuel remain in the carburator over long periods, or the passages of the carburator may become clogged with impurities, and malfunctions may result. Periodic maintenance is vital to the safe and efficient operation of your engine. Check the table below for periodic maintenance intervals. 6.
3. INSPECTING THE SPARK PLUG 5-w w) (See Fig.5 (1) Clean off carbon deposits on the spark plug electrode using a plug cleaner or wire brush. (2) Check electrode gap. The gap should be 0.6 mm to 0.7 mm (0.02 inch.-0.03 inch.). Adjust the gap, if necessary, by carefully bending the side electrode. NOTE Clean and replace air cleaner elements more often when operating in dusty environments. Replace the element in case that dirt or dust can not be removed and/or that the element is deformed or deteriorated.
7. PREPATIONS FOR STORAGE 9. EASY TROUBLESHOOTING 6) 1. DISCHARGE FUEL (See Fig.6 WHEN ENGINE WILL NOT START : WARNING Flame Prohibited If you do not use the engine more than 1 month, discharge fuel to prevent gum in the fuel system and carburetor parts. ■ Remove the fuel cup, place it over a container and open the fuel cock to discharge fuel from the fuel tank. ■ Remove the drain screw of the carburetor float chamber and discharge fuel.
10. SPECIFICATIONS MODEL EX30D Type Air-cooled, 4-cycle single cylinder, overhead camshaft, gasoline engine Displacement mL (cc) Continuous Output kW/rpm (HP/rpm) 5.5/3600 (7.5/3600) Maximum Output kW/rpm (HP/rpm) 6.6/4000 (9.0/4000) Direction of Rotation Counterclockwise, as Viewed from P.T.O. Shaft side Lubricant Oil Capacity JP Automotive detergent oil (API/ SE or higher grade, SAE/ 10W-30 etc.