Portable Generator User Manual

(3) MULTI MONITOR
■■
LED display
Operation hour, voltage and frequency are
indicated in turns by means of depressing the LED
display changeover switch. In addition, "O_Lod"
(overload) will be indicated when the generator is
in the overload condition or appliance(s) is out of
order.
In this case, stop the engine immediately and check
the appliance and/or generator for overloading.
After the check and remedy, restarting the engine
will resume displaying in the normal manner.
■■
Operation hour lamp
Lamp (red) is turned on when LED display is changed over into operation hour indication.
■■
Voltage lamp
Lamp (red) is turned on when LED display is changed over into voltage indication.
■■
Frequency lamp
Lamp (red) is turned on when LED display is changed over into frequency indication.
■■
LED display changeover switch
When depressing this switch, indication in LED display is changed over in turns;
operation hour → voltage → frequency → operation hour.
When starting the engine, operation hour is indicated in LED display at first.
■■
Auto-power saving switch
When depressing this switch, auto-power saving function is activated.
■■
Auto-power saving lamp
Lamp (green) is turned on while auto-power saving function is activated.
■■
Engine oil level warning lamp
When the engine oil level is lower than the specified level, the lamp is turned on.
Then engine will be stopped.
– 8 –
RG4300i / RG3200iS / RG4300iS
(With electric starter)
RG2800i / RG3200i / RG2800iS
STOP
RUN
CHOKE
STOP
RUN
START
ENGINE SWITCH
ENGINE SWITCH
Hours
MULTI MONITOR
V
Hz
AUTO
P-SAVE
LED display Operation hour lamp
Voltage lamp
Engine oil level
warning lamp
Frequency
lamp
Auto-power
saving lamp
Auto-power
saving switch
LED display
changeover switch
(1) ENGINE SWITCH
The engine switch is designed for easy operation with the interlocking
mechanism between the fuel cock and the choke furnished.
(2) KEY SWITCH for electric starting models.
To start the engine with electric starter.
CHOKE
To start the engine, turn the knob to the position.
(Choke valve is closed.)
RUN
Keep the knob in this position after the engine
starts. (The engine can be started with the knob at
this position when the engine is warm.)
STOP
To stop the engine, return the knob to the position.
(The fuel cock is closed as well.)