Portable Generator User Manual

5-3-8 WIRE BAND
Cut the wire bands that are binding wires behind the
control panel.
For electric start models, cut the wire band that is binding
battery cables also.
Tools : Nipper
Wire band
(3) Loosen the five bolts and remove the cover bracket
from the inverter unit.
M6 x 12mm Flange bolt : 2pcs.
M6 x 18mm Flange bolt : 2pcs.
M6 x 25mm AY Bolt : 1pce.
NOTE : At this step, electric wires are still connected to
the control panel. Therefore, do not try to
separate the control panel forcedly. Separate the
control panel after removing fuel tank at "5-3-9
FUEL TANK".
Muffler cover
(Rear)
5-3-7 REAR COVER
(1) Remove the muffler cover.
M6 x 18mm Flange bolt : 6pcs.
Tools : 10mm Box wrench
Rear cover
(Upper )
(2) Remove the upper rear cover.
– 25 –