Instructions / Assembly

– 31 –
Step Parts to remove Remarks and procedures Fasteners
30
Crankcase
*Oil pump
*Oil filter
*Oil pressure switch
*Oil pump filetr
*Oil relief spring & ball
*Governor lever shaft
(1) Disconnect wire connector from oil pressure
switch, and remove switch.
(2) Remove oil filter and adapter.
(3) Remove oil pump filter.
(4) Remove oil relief plug and take out spring
and ball. (Make sure spring is jumped out.)
(5) Take out snap pin and pull out governor
shaft. (Make sure not to loose washer.)
(6) Remove oil pump cover, outer rotor, inner
rotor and o-ring.
M6 x 28 Flange bolt : 3 pcs.
10-32 x 11: 1 pc.
M14 x 12
M6 x 14 Flange bolt : 4 pcs.
STEP 30
STEEL BALL
OIL PUMP FILTER
SPRING, relief valve
GASKET, aluminum
PLUG, oil relief
10-32 FLANGE
BOLT
(
Inch
)
GOVERNOR LEVER
SHAFT
WASHER
SNAP PIN
M6 FLANGE BOLT
OIL PUMP COVER
O RING
INNER ROTOR
OUTER ROTOR
WASHER
M6 FLANGE BOLT
ADAPTER, oil cooler
OIL PRESSURE SWITCH
OIL FILTER
O RING
OIL PRESSURE SWITCH
OIL FILTER
[EH65]