User's Manual

4 5
Waterproof Case and Bluetooth Controller Assembly and Use
3
Phone Installation
2
Push the tray with the phone fixed into the waterproof case. Note that the
handle of the tray should be on the same side of the seal cap. Then tighten the
seal cap knob.
Tear off the protective film that covers the nanometer light adhesive in the
phone tray and inspect the front and back camera positions of the phone.
After ensuring that the front and back viewfinders are not obstructed, press the
back of the phone against the adhesive so that the phone is stuck in place in
the preset position.
As shown in the figure below, insert the waterproof case into the Bluetooth controller
and twist the knob on the back of the controller clockwise to secure it in place.
Use proper force when twisting the knob. Excessive force may damage the
controller.
2. Controller status indicator lights
1. Attaching the waterproof case to the controller
Flashing blue Bluetooth disconnect
Steady blue Bluetooth connect and controller in sufficient battery
Flashing red Controller battery less than 10%
Steady red Controller being charged
Steady green Controller battery fully charged
BLUE
BLUE
RED
RED
GREEN
The nanometer light adhesive is designed to work on the phone itself, so
remove any case or shell from the phone to avoid problems when you try to
remove the phone from the tray.
After using the case many times, the adhesive may lose its stickiness. At such
a time, rinse the adhesive surface with water to make it usable again.
1.
2.
EN