SubSurface Instruments, Inc. 1230 Flightway Drive De Pere, WI 54115 PH:920-347-1788 FX:920-347-1791 www.ssilocators.com Email: info@ssilocators.
Table of Contents Notes: Features ....................................................................... 3 Controls Description ................................................... 4 Display Description ..................................................... 5 Function ....................................................................... 6 Operation ..................................................................... 7 Connections .................................................................
Features Notes: 14 Standard unit with internal battery housed in a high impact ABS case. Included accessories: Manual Wall transformer for recharging battery Rechargeable sealed lead acid battery (internal) 12 Volt auxiliary power cable RS-232 Cable 30’ Sensor cable Accessories store in compartment in lid. Electronic control unit. Titanium encased waterproof Sensor . Waterproof optional cables available: 50’, 100’ Other lengths special order.
Controls Description Warranty Statement SubSurface Instruments, Inc. warrants the BHG-1 to be free from defects in material and workmanship for a period of twelve (12) months from date of shipment to original purchaser, subject to the following conditions. Our obligation under this warranty is limited to servicing or adjusting any product returned to the factory for this purpose, and to replace any defective part thereof.
Included Accessories Display Description Wall Transformer Serial Port Cable 1. Bar Graph (top).............. Shows signal strength and polarity 2. BATT Icon .................. Flashes when battery needs charging 12 Volt Power Cable 3. Numeric output ............ Indicates signal value in Milligauss ................................................. dependent upon range setting, ................................................ or battery voltage when BATT ...............................................
Function The BoreHole Gradiometer (BHG) responds when the magnetic field strength measured at the two sensor elements inside the Sensor housing are different. This difference is measured in “Differential Milligauss” and is reported to the user via the LCD display and the audio speaker. A headset may be used in noisy environments and will disable the speaker when connected. The RS-232 interface allows control and recording using a personal computer with a serial COM port.
Maintenance Operation Keep the unit as clean as possible, especially the Electronics keypad panel. Do not use an abrasive cleaner on the keypad overlay or the LCD lens. Connect the sensor to the electronics using the sensor cable before turning the system on. Press the green ON button to turn on the BHG . To turn OFF press the red OFF button. The RS-232 interface cannot be used to turn the BHG on or off. The Titanium encased sensor has no user serviceable parts.
Connections The headphone jack has a water resistant cover. Lift open to plug in a stereo phone plug to listen with a headset in noisy environments. Replace a blown fuse with a 1/4 amp slow blow. RS-232 Interface COM Port settings: Baud rate Bits Parity Stop bit Flow Control 9600 8 NO 1 None Program: Use the included RS-232 cable to connect the MUL to a computer. To run on external power or to charge the battery in the field, connect the external DC power cable to the POWER connector.