Built-In Side Panel Instructions

Metal Side Panel (with Optional Base Cover)
7015550 / Rev A / February, 2010
Page 3 of 3
HANG SIDE PANEL:
1. With the side panel held at an angle to the side of the unit, engage the front brackets behind the mainframe
(See Figure 3 and Figure 5), then rotate the back of the panel toward the unit so the front brackets hook in
behind the mainframe (See Figure 4 and Figure 5) and the slots at the back of the side panel align with the
rear bracket hooks (See Figure 5).
2. With the side panel tight against the side of the unit, pull the side panel down so the bracket hooks engage
the tops of the slots at the back of the side panel.
NOTE: After unit is slid into position, adjust optional base cover at this time (See Figure 5). If base cover
needs to be removed, unit must be pulled from installation so base cover can be slid toward back
and out through rear slot of the side panel .
Figure 5. Hanging Side Panel, Rear View
BASE COVER
(OPTIONAL)
SIDE
PANEL
BRACKET
(REAR)
SIDE
PANEL
SIDE PANEL
MAIN FRAME
Figure 3. Hanging Side Panel, Top View
SIDE PANEL
MAIN FRAME
Figure 4. Hanging Side Panel, Top View