User's Manual

Suga Electronics Limited
© Suga Electronics Limited. All Rights Reserved.
Information in this document is subject to change without prior notice.
P. 5
2. Software Installation
2.1 COM port check
Under Windows, run Device Manager. Check the physical COM port assignment. For
example as in below picture, the COM port is COM7.
2.2 Software Configuration Tools
(1) Run “Lab Tool for WiFi
V1.30” confiuguration tool. Check that the virtual COM
port (WMT, BT, GPS) is same as those in below picture.
(2) Fill into the PHY port the correct physical COM port (COM7). Click Enable.
(3) Put the patch file “Patch_e3_20120405.bin” into any location in harddisk, e.g.
“:\C”.
(4) For BT/GPS, fill Virtual COM to be 31, click Open Port.
(5) Click Select > Select the patch file > Path. Wait until the log area reports
successful.
(6) Click BT or GPS to enable BT or GPS.
(7) Read MAC address if necessary.