User's Manual

4
Chapter 2 Installation Procedure
2.1 Software Installation
2.1.1 Overview
The Adapter’s Setup Wizard will guide you through the installation procedure for Windows
98SE, Me, 2000 and XP. The Setup Wizard will guide you install the Utility and drivers.
If you install the hardware before the software, you will be prompted “Found New Hardware
Wizard”, click the Cancel button, and run the Setup Wizard program on the CD-ROM.
The Setup steps for Windows 98SE, Me, 2000 and XP are very similar. The following setup
steps are for windows 2000.
2.1.2 Software Installation for Windows 2000
1. Insert the Resource CD into your CD-ROM drive, click the Start button and choose Run.
In the field that appears, enter F:\XXX\Setup.exe (if “F” is the letter of your CD-ROM
drive; XXX presents the setup program path, which is labeled on the Resource CD), Figure
2-1 should then appear.