User Manual
Table Of Contents
- Overview
- Terminology
- Overview Diagram
- 1. 7 Segment Display
- 2. Preset/Select/Hold To Edit Buttons
- 3. Up & Down Buttons
- 4. Mix Knob
- 5. Lo Cut Knob
- 6. Hi Cut Knob:
- 7. Bypass LED
- 8. Bypass/Preset Down Switch:
- 9. Time Division LEDs
- 10. Division Button
- 11. Regen Knob
- 12. Time Knob
- 13. Modulation Depth Knob
- 14. Modulation Waveform Display & Select Button
- 15. Modulation Speed Knob
- 16. Tempo LED
- 17. Tap-Tempo Switch
- Inputs & Outputs
- Controls
- Presets
- MIDI
- Global Settings
- Example Settings
- Usage Cases
- Technical Specifications
- Warranty
- FCC Compliance
Discovery Delay – Overview DiagramOverview Diagram
10
Revision: 1.2 (7/1/2021)
12. Time Knob
e time knob can be used to alter the milliseconds (in 5ms increments) or BPM
(range 55-250BPM), depending on which is shown on the display� e range in mil-
liseconds accessed by the knob is 40ms - 1100ms� You can manually adjust millisec-
ond/BPM times (in 1ms increments) with the [▲] and [▼] buttons to get specic
delay times�
13. Modulation Depth Knob
e depth knob controls how intense the modulation of the delay is�
14. Modulation Waveform Display & Select Button
is button selects one of the 3 waveforms (Triangle, Sine, and Square) to modulate
the delay time with�
15. Modulation Speed Knob
e speed knob controls the speed of a LFO (low frequency oscillator), which con-
trols the delay time around the center of what is displayed on the display� is results
in a chorus-type eect�
16. Tempo LED
is LED ashes at the tempo of the delay time (Milliseconds)�
17. Tap-Tempo Switch
Tap more than once to set the quarter-note delay time�