User Manual

Table Of Contents

Discovery Delay – PresetsPresets

Revision: 1.2 (7/1/2021)

3. Set the knobs to your desired settings� For expression pedal editing, refer to bot-

tom of this page�

4. Press [PRESET SELECT] button again� e display will read

8888

and

show a preset location while blinking�

5. Use the [▲] and [▼] arrow buttons to select which location you want to store to�

6. Press the [PRESET SELECT] button one more time�

7. is display will show

8888

aer saving is complete�

Mapping Expression pedal

Requirement: A low resistance 10K ohm expression pedal should be used.

If the expression pedal has a limit knob, set it so the expression pedal is work-

ing with its full range.

1. Edit a preset by holding down the [PRESET SELECT] button�

2. Once editing a preset and the display is blinking, tilt the expression pedal com-

pletely to the top (toe) or bottom (heel) position�

3. When in the top/bottom position, you should see a dot in the center of the dis-

play indicating you are in the right area� Set your controls as desired for this posi-

tion�

4. Tilt the expression pedal completely to the opposite direction, and repeat step 3�

5. Tilt the expression back and forth while playing to determine if the desired map-

ping is correct�

8888