User Manual
Table Of Contents
- Overview
- Terminology
- Overview Diagram
- 1. 7 Segment Display
- 2. Preset/Select/Hold To Edit Buttons
- 3. Up & Down Buttons
- 4. Mix Knob
- 5. Lo Cut Knob
- 6. Hi Cut Knob:
- 7. Bypass LED
- 8. Bypass/Preset Down Switch:
- 9. Time Division LEDs
- 10. Division Button
- 11. Regen Knob
- 12. Time Knob
- 13. Modulation Depth Knob
- 14. Modulation Waveform Display & Select Button
- 15. Modulation Speed Knob
- 16. Tempo LED
- 17. Tap-Tempo Switch
- Inputs & Outputs
- Controls
- Presets
- MIDI
- Global Settings
- Example Settings
- Usage Cases
- Technical Specifications
- Warranty
- FCC Compliance
Discovery Delay – MIDIMIDI
23
Revision: 1.2 (7/1/2021)
MIDI
Changing MIDI Channel:
1. Power on the unit while holding the [PRESET SELECT] button�
2. Press the [▼] button until you see
8888
�
3. Use the [▲] and [▼] buttons to select the channel�
4. Press the [PRESET SELECT] button to select the channel�
5. When complete, you will see
8888
on the menu again� Scroll down with [▼]
until you see
8888
�
6. Press [PRESET SELECT] to nishing editing the global settings�
Changing Presets With Program Changes (PC#s)
Discovery’s presets can be changed via Program Changes coming from any MIDI
device, being that a MIDI switcher or DAW, or really anything that can send a Pro-
gram Changes via a 5-pin MIDI cable�
1. Be sure the Discovery and your MIDI device are transmitting on the same MIDI
channel� For directions on changing Discovery’s MIDI Channel, please refer to the
instructions in the section above�
2. Connect the MIDI OUT from your MIDI device via 5-pin MIDI cable to the
[MIDI IN] of your Discovery�
3. Send Program Changes from your MIDI device to change the presets of your
Discovery� For a MIDI table with PC#s and corresponding a Discovery presets, refer
to page 28�