User Manual

EXCLUSIVE FEATURES
FX Link
The FX Link can be utilized to remotely control the pedal. Shorting the shield to the tip
will activate the pedal. ( ⅛” Mono Jack)
Right: Koji will power up in the ON state.
Center: Koji can be switched remotely via the FX Link jack. In this position Koji’s
state will be dictated by the status of foot switch connected to the jack. If
the FX Link jack is not utilized, Koji will power up in the OFF state.
Left: Koji will power up in the OFF state.
Battery Monitor
Upon Koji powering up, the battery voltage is measured. If the voltage measured is
lower than 5.5V, Koji’s LED will flash 3 times to alert you that it’s time to replace the
battery. Once the 9V battery is replaced, normal operation will resume. Should a
battery fail completely (<5V), Koji will switch itself into True Bypass mode and the LED
will begin to flash. This feature ensures that your signal will continue uninterrupted and
undistorted until you can replace the battery with a new one.
Note: The LED flash can be defeated by pressing the footswitch to turn it off.
FX Link Switch Position
LEFT CENTER
RIGHT