Quick set-up User Manual

ManualsBrandsSulky ManualsControl panelVISION 2 WPB

The following instructions are given to enable a quick start

of the control box by using the 3 main menus:

• MAIN (button ref. 8)

• INFORMATION (button ref. 9)

• SETTING (button ref. 10)

and for each one their scroll down sub-menus.

Vision II WPB

Continuous weighing

QUICK-START GUIDE

Turn on the power

For further information, read the user manual

Ref : 400 363- GB/DIS-00

Summary of content (6 pages)

PAGE 1
Vision II WPB Continuous weighing QUICK-START GUIDE The following instructions are given to enable a quick start of the control box by using the 3 main menus: • MAIN (button ref. 8) • INFORMATION (button ref. 9) • SETTING (button ref. 10) and for each one their scroll down sub-menus.
PAGE 2
SETTING MENU “SET” Select the SET menu and perform in order the following operations FORWARD SPEED CALIBRATION NB : Speed calibration is done over a distance of 100 m • Mark out a distance of 100 m • Position the tractor at the 1st mark 1 0m 100m M A 2 m/Pulse I N m/Pulse m/Pulse m/Pulse 1. 2. 3. 4. 1.000 1.000 2.000 0.016 5.
PAGE 3
PROGRAMMING THE WORKING WIDTH 1 2 1 2 3 &- ABC DEF 4 5 6 GHI JKL MNO 7 8 9 PQRS TUV WXYZ 0 Enter the width (in metres) on the numeric keypad.
PAGE 4
… AND CHOOSE THE CALIBRATION MODE 3 4 • Select activate the STAT to mode • Press to exit NB : Always start with the STAT mode FILL THE HOPPER MAIN MENU “MAIN” Select the main menu MAIN and perform the following operations in order Presentation of the MAIN menu 1 2 3 4 5 6 7 Time Speed Rate being spread kg/ha Shows position of electric actuators connected to rate shutters Rate modulation +10% Rate modulation -10% and return to initial rate setting after a modulation of +/- 10% TRIBORD 3D control: Y
PAGE 5
FERTILISER CALIBRATION IN STATic MODE STATIC MODE This has already been pre-selected from the SET menu (settings) 1 2 • This message appears • Wait until the message disappears before starting to spread • Press • « TEST » flashes 3 4 • This message appears • The calibration (T-factor) has been saved • After 200 kg has been spread, « STOP » flashes • Stop spreading when possible and when the tractor is on a flat area (shutters closed) • Press « STOP » • Repeat the fertiliser calibration in the STATic
PAGE 6
.… FERTILISER CALIBRATION IN DYNamic MODE 1 IMPORTANT • Activate « STOP » during transport on roads or refilling • Select the AUTO mode • Do not use the DYNamic mode when refilling from a front tank on the move • During spreading, there is automatic rate correction. • The DYNamic mode moves to « STOP » when the hopper contents < 200 kg INFORMATION MENU “INFO” Select the INFO menu to check spreading performance.