Product Manual
Table Of Contents
- Safety
- Description
- 2.1 Introduction
- 2.2 Compressor Component Description
- 2.3 Compressor Cooling And Lubrication System — Functional Description
- 2.4 Compressor Discharge System—Functional Description
- 2.5 Control System — Functional Description
- 2.6 Air Inlet System, Functional Description
- 2.7 Controller/Keypad
- 2.8 LCD Display
- 2.9 LED LIGHTS
- Specifications
- Installation
- Operation
- Maintenance
- 6.1 General
- 6.2 Maintenance After Initial 50 Hours of Operation
- 6.3 Maintenance Every 2000 Hours
- 6.4 Fluid Maintenance
- 6.5 Filter Maintenance
- 6.6 Air Filter Maintenance
- 6.7 Separator Maintenance
- 6.8 Belt Maintenance
- 6.9 Replacement and Alignment of Belt Pulleys
- 6.10 Hose Maintenance
- 6.11 TANK MOUNT PACKAGE MAINTENANCE
- 6.12 Troubleshooting – Introduction
Section 6
SHOPTEK
™
USER MANUAL
57
02250180-090 R00
MAINTENANCE
6.1 GENERAL
This compressor requires a minimal amount of
inspections and maintenance. The Controller and
other indicators alert the operator to situations
requiring maintenance, or fault conditions.
6.2 MAINTENANCE AFTER
INITIAL 50 HOURS OF
OPERATION
After the initial 50 hours of operation, maintenance is
required to clean the system of any foreign materials.
At this time the return line strainer should be cleaned.
Refer to Figure 6-1 and Figure 6-2.
WARNING
Before any repairs are attempted, refer to
Section 1: Safety before proceeding.
Figure 6-1: Return Line Strainer
ST400, ST500, ST700, 5-10HP
1. Strainer
2. Separator Tube