Product Manual
Table Of Contents
- Safety
- Description
- 2.1 Introduction
- 2.2 Compressor Component Description
- 2.3 Compressor Cooling And Lubrication System — Functional Description
- 2.4 Compressor Discharge System—Functional Description
- 2.5 Control System — Functional Description
- 2.6 Air Inlet System, Functional Description
- 2.7 Controller/Keypad
- 2.8 LCD Display
- 2.9 LED LIGHTS
- Specifications
- Installation
- Operation
- Maintenance
- 6.1 General
- 6.2 Maintenance After Initial 50 Hours of Operation
- 6.3 Maintenance Every 2000 Hours
- 6.4 Fluid Maintenance
- 6.5 Filter Maintenance
- 6.6 Air Filter Maintenance
- 6.7 Separator Maintenance
- 6.8 Belt Maintenance
- 6.9 Replacement and Alignment of Belt Pulleys
- 6.10 Hose Maintenance
- 6.11 TANK MOUNT PACKAGE MAINTENANCE
- 6.12 Troubleshooting – Introduction
SHOPTEK
™
USER MANUAL SECTION 2
18
02250180-090 R00
2.7 CONTROLLER/KEYPAD
Refer to Figure 2-9. The Controller keypad has two
main pads for compressor control. To start the
compressor operation, press the green Start pad
.
To stop compressor operation, press the red Stop
pad . The Run mode indicator lights up
whenever the control is in an operating mode.
2.8 LCD DISPLAY
The display's normal view shows the compressor
package's discharge pressure, internal temperature,
operating mode, and load status. The modes are
MANUAL, STOP, AUTOMATIC, or FAULT.
Refer to Figure 2-10. If a machine fault occurs, the
red fault indicator will light up, and the display will
indicate that a fault has occurred.
Figure 2-10
®
X
S
1
2
3
4
5
67891011
Figure 2-9: Controller Panel
1. Run Mode Indicator Light (Green) 6. Start Button
2. Power On Indicator Light (Red) 7. Return/Reset Button
3. Fault Warning Indicator Light (Red) 8. Cursor/Confirm Button
4. Display Panel 9. Up Button
5. Stop Button 10. Down Button
11. Set/Load/Unload Button
STOP:
RTD Fault