Product Manual

UTILIZATION
x
Only use the sleeve (couplings) specifically recommended for connecting
these tools to the supply air hose (except for tools with rotating
connections).
x
Never pressurize an air hose (except during controlled venting) when not
connected to the tool.
x
Use only a constant compressed air supply for the equipment and do not
exceed the maximum rated pressure, 7 bar or 100 psi.
x
Do not use these tools for purposes for which they were not
designed.
x
Never use these tools without a steel (bit) or without the steel (bit) being
completely inserted and latched or retained
properly.
x
Before any work, make sure that the steel (bit) cannot come in contact with
any ducting or container transporting or containing fluids or electrical,
telephone or other cables.
x
Never point these tools or compressed air hose towards people or animals.
x
To avoid any risk of sudden pressurization (air hose whipping risk)
x
The compressor air valve should be opened progressively.
x
Prior to start up, operator should be in a stable position and holding
the tool firmly with two hands without pressing on the trigger or
throttle.
x
Start up the tool progressively to avoid any unexpected toolsteel (bit)
movements on the working surface.
x
Make a tapping hole of a few cm / in. before drilling with full power.
x
Never hold the tool by the clamp (hose).
x
Orient the exhaust orifices to avoid any dangerous projections.
x
Never manipulate the steel (bit) without gloves, because of the burn
danger.
x
Never let the steel (bit) rest on a foot.
x
Never allow the tool to lean on its trigger, to avoid uncontrolled
start-ups.
x
Never leave the tool unprotected on the ground in dirt or mud.
x
Never use the air hose to move these tools.
x
Stop the tool before moving it.
x
After every shutdown, check all connections before re-pressurizing the
air hose and tool operating system.
x
Never disconnect a pressurized air hose without having shut off the air
supply service valve. Wait until system has vented or make sure it has
vented by running the tool until all pressure has been released.
x
When not in use, disconnect the tool to avoid accidental restarting.
Store the air tools under cover and out of reach of children.
SAFETY INSTRUCTIONS
5
Subject to EAR, ECCN EAR99 and related export control restrictions.
02250218-226 R03
©
2015 Sullair, LLC.
Update: August 05 2015