User's Manual

Temperature
3 month
-20
25
40
1 month
-20
25
40
Operating humidity
Environmental humidity around the
product normal work
10%
70%
90%
Storage humidity
Storage temperature product
Storage humidity product doesn’t
work
5%
70%
90%
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF exposure compliance statement:
This device has been evaluated to meet the general RF exposure requirement
NOTE: This device complies with part 18 of the FCC Rules.
Information to the user.
1. The device has potential interference, but the interference is very small and meets the
requirements of the FCC rule
2. Equipment system maintenance is simple, please refer to the manual
3. The user can take simple measures to correct the interference. Such as staying away
from interference sources, turning off interference sources, etc.