Installation Guide

SUMERAIN S1208CW INSTALL MANUAL

1. Please check below accessories of S1208CW and make sure you get complete

accessories.

① Glass spout x 1

② Front panel x 1

③ Handle body x 1

④ Mixer water connection pipe x 1

⑤ Rubber ring x 2

⑥ Screw x 1

⑦ Nut x 1

⑧ Plastic Expansion Nails x 1

⑨ Screw x 1

2. Rollback the flange cover and dismounting the handle body from assembled front panel

PAGE 1
SUMERAIN S1208CW INSTALL MANUAL 1. Please check below accessories of S1208CW and make sure you get complete accessories. ① Glass spout x 1 ② Front panel x 1 ③ Handle body x 1 ④ Mixer water connection pipe x 1 ⑤ Rubber ring x 2 ⑥ Screw x 1 ⑦ Nut x 1 ⑧ Plastic Expansion Nails x 1 ⑨ Screw x 1 2.
PAGE 2
3. Inspect hot and cool water tube, please clean it at first if necessary 4. Connect the one side of (④)Mixer water connection pipe with handle body’s mixer connector , and then Connect your house hot water tube and cool water tube with handle body’s hot water connector and cool water connector separately 5.
PAGE 3
enough. 6. Insert the glass spout into the front panel’s arc hole which has the white rubber ring, till the mounting hole of glass spout reach the right place, right underneath of mounting hole of panel’ s backside.
PAGE 4
7. Mounting the glass spout with front panel by screw and nut, In order to avoid broken the glass, please don’t forget to add the two black rubber rings between glass two sides. 8. Mark the position of mounting hole of front panel and drill suitable hole to impact the plastic expansion nail. 9. Mounting the handle body into front panel if it has fixed by cement which is dry enough.
PAGE 5
10. Tighten all the connectors and inspect whether faucet running normally, tighten the screw and mounting the front panel into wall if everything is ok.