Faucet Series Installation Guide Service Hotline Total Free 4000-999-075(China) +1-408-867-8884(America) www.sumerain.
Table of content 1. IMPORTANT INSTRUCTIONS ----------------------------------------------------------- 2. FA U C E T E X P L O S I O N - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2 3 3. FA U C E T S I N S TA L L AT I O N - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 6 4. TROUBLESHOOTING --------------------------------------------------------------------9 5.
A1 FAUCET WITH ONE HOLE Ⅰ 1 handle 2 faucet body 3 O-ring washer 4 Semi-circular rubber washer 5 Semi-circular metal-friction 6 mounting nutⅠ 7 mounting screw 8 hoses Ⅱ 2/8 1 aerator 2 spout 3 handle 4 faucet body 5 O-ring washer 6 plastic washer 7 shank 8 mounting nut Ⅱ 9 hoses
A2 FAUCET WITH THREE HOLES A3 FAUCET WITH FIVE HOLES 3/8 1 spout 2 O-ring washer 3 nipple 4 G 3/4” black washer 5 nut 6 washer ⅰ 7 triple tube 8 handle 9 decorate seat 10 washer ⅱ 11 washer ⅲ 12 nut 13 Ceramic cartridge 14 Triple valve 15 hoses
1 spout 2 O-ring washer 3 nipple 4 G 3/4” black gasket 5 nut 6 shunt valve 7 Shower hoses 8 handle 9 Decorate seat 10 washer ⅱ 11 washer ⅲ 12 nut ⅰ 13 Ceramic cartridge 14 Water inlet valve 15 shower 16 Shower sheath 17 washer ⅱ 18 washer ⅲ 19 nut ⅱ 20 21 20 cm hose 40 cm hose A4 KITCHEN FAUCET 4/8 1 Faucet body 2 hose line 3 Spray head 4 handle 5 shank 6 washer ⅰ 7 washer ⅱ 8 nut 9 screw 10 cold water supply hose 11 hot water supply hose 1
FAUCET INSTALLATION A1. Faucet with One Hole Step 1: Begin installing your faucet by placing the O-ring washer and faucet in position on the sink. Check the faucet and the O-ring washer position; make sure the base of the faucet is parallel to the back of the sink. Step2: From under the sink tighten the mounting nuts, making certain not to over-tighten which could damage the nuts and make them difficult to remove in the future. Step3: Screw on washers and mounting nuts.
adjust the way and place, screw down the control water body’s lockup nut, make it fix on the basin. At last install back the handle according to the remove step. : The control water body with the red sign installs on the left and connects with hot water; with blue sign install on the right and connects with cold water. Step3 Put the O-ring wash under the faucet body, adjust the place, from under the basin, put on the G 3/4” black washer, then screw on the nut, connect the triple tube to the nipple.
TROUBLESHOOTING Symptom Solution Faucet leaks from the handle A. B. A. The water pressure Tighten the packing nut Replace the "O" ring or packing Make sure the water supply valves under the sink are turned on all the way B. Clean or replace the aerator is too low C. Check plumbing system for water pressure problems The spout sprays A. Clean or replace the aerator water all over B. Replace the aerator washer Water is leaking A.