Installation Guide

FAUCET INSTALLATION
A1. Faucet with One Hole
Step 1: Begin installing your faucet by placing the O-ring washer and faucet in position on the
sink. Check the faucet and the O-ring washer position; make sure the base of the faucet is
parallel to the back of the sink.
Step2: From under the sink tighten the mounting nuts, making certain not to over-tighten which
could damage the nuts and make them difficult to remove in the future.
Step3: Screw on washers and mounting nuts. From underneath the sink, screw the
Semi-circular rubber washer and Semi-circular metal-friction and the mounting nuts onto the
mounting screw or shank (if it’s a shank), then tighter the mounting screw with a basin wrench.
Step4: Connect the water hoses to faucet shank, tighter the coupling nuts with a basin wrench.
Step5: Attach the faucet hoses. Attach the faucet hoses to the shutoff valves. Hand-tighten the
nuts, then give them extra quarter-turn with an adjustable wrench. To prevent damage to the
tubes, it’s a good idea to hold the valve with another wrench while you tighten them.
Step5:
All that left to do is turning the water on and check all the connections to ensure everything is
working correctly.
This assembly instructions can be used for one hole bathroom faucet, one hole kitchen
faucet, and one hole bidet faucet.
To the LED faucet with 4 batteries, the above five installation steps is applied, besides,
need to connect the supply line to the battery box at last.
A2 Faucet with three holes or five
Step1 Before installation ensure there are three (or five) Φ32~Φ35mm holes on the basin (or
bathtub), the faucet body’s bottom must put the O-ring; remove the faucet body bottom’s fixation
part.
 5/8

Step2 Remove the handle, decorative seat from the control water body. Put the control water
body through the basin bottom (bathtub bottom), connect with the decorate seat and handle,