TROUBLE SHOOT: Low or No Water Pressure Out of Pump + Make sure batteries are fresh and have bean inserted correctly. * Remove lid on shower unit and fill with clean water. Do not exceed max ill line inside reservoir. * Ensure the hose is not pinched. Maximizing Bubble Performance + Make sure batteries are fresh and have been inserted correctly. + Make sure water level is not above or below 1° + Bubble Tracks may need cleaning, see instructions on page 7.
A WARNING Drowning Hazard: Babies have drowned while using infant bath tubs. To prevent drowning: « Stay in arm’s reach of your baby. + Never rely on a toddler or preschooler to help your baby or alert you to trouble. Babies have drowned even with other children in or near bath tub. © Babies can drown in as little as 1 Inch of water. Use as little water as possible to bathe your baby. + Use in empty adult tub or sink. + Keep drain open in adult tub or sink.
TO USE (continued): COMPONENTS: Step 3: Hook clip on frame (Figures L & M). Infant Tub Step 4: Flip fabric over frame (Figure N). Loop elastic bands on side of fabric sling onto plastic frame notches (Figure O), both sides. WARNING: To prevent injuries, make sure sling is always led properly before Bath Sling Frame Spa Connector Newborn Use: Position bath sling on the bottom of the sink. Place newborn on bath sling to bathe (Figure P). Never leave child unattended while in sink.
BATTERY INSTALLATION: TO USE: Shower, Bubbling Spa & Whirlpool Unit Shower, Bubbling Spa & Whirlpool Unit Step 1: To remove Shower, Bubbling Spa & Whirlpool Unit lid, hold top of lid and push reservoir back until you hear a click (Figure A). Pull lid from the back edge until it releases, Step 2: Use screwdriver to open battery compartment door {Figure B). Step 3: Insert 4 New alkaline “D” batteries into battery compartment. Be sure to install the batteries properly and in the right direction.