Installation Guide

13
Should you encounter any problems, contact Customer Service at [phone] from 8AM to 5PM MST, Monday-Friday.
Extended operating days and hours during peak season requirements.
OWNER’S MANUAL
the parts, and liberally lubricate the Skimmer Gasket Rubber Seal 25 with petroleum jelly. Then reassemble them back onto the Skimmer Canister 9 .
b. Remove the Motor Assembly 3 by turning open the Motor Seal Nut 1 . Clean and dry completely the Pump.
Then see STEP 3: Pump Reassembly/Replacement (p. 15-16) to reassemble the Motor into the Canister.
4. Store all the parts in a dry place that remains above 32°F (0°C) at all times.
PUMP SERVICING INSTRUCTIONS
The most efficient way to troubleshoot or replace the Pump is to disassemble the entire filtration system. Please drain the water level to below the pool’s Skimmer
Opening, then disassemble the system following the steps below.
CAUTION:
1. You may get wet.
2. Please read and follow the instructions carefully. Incorrect handling may cause damages resulting in leaks between the Skimmer Canister 9 and the pool wall.
3. REMEMBER TO KEEP ALL THE PARTS IN A SAFE PLACE FOR REASSEMBLY LATER.
STEP 1: Removal of Motor Assembly 3
1. Turn the Pump off, and unplug it from the power outlet.
2. Slide open the Skimmer Top Cover 5 , remove the Strainer Basket and the Filter Cartridge and any chlorine tablets left inside.
3. At the Return Fitting 18 :
a. Unscrew and remove the RF Locking Ring and RF Diverter. Then insert the Service Plug to block the water flow.
b. Loosen the Hose Clamp attaching to the 90° Elbow 13 . Carefully detach the Hose, and let the water drain from the Hose and the Canister.
NOTE: you may also detach the other end of Hose attaching to the Canister, but it is not required.
4. Unscrew the Skimmer Seal Ring 22 to remove the entire filtration system from the pool.
5. Flip the Canister upside down. Unscrew the Motor Seal Nut 1 and take out the Motor Assembly.
PUMP SERVICING INSTRUCTIONS
CAUTION: you will need two people for some of the steps. Incorrect handling may cause damages resulting in leaks between the Skimmer Canister 9 and
the pool wall.
3. Put a water container (not included) under the Skimmer to collect water.
Slide open the Top Cover 5 , and take out the Strainer Basket 24 and
Filter Cartridge 7 .
4. Have one person holding the Water Stopper and Skimmer Canister 9 ,
while the other person unscrews the Motor Seal Nut 1 .
CAUTION: DO NOT PUSH OR PULL THE CANISTER as this may cause
damage between the Canister and pool liner.
1. Turn the Pump off, then unplug it from the power outlet.
2. Block the water flow:
a. Unscrew and remove the RF Locking Ring 20 and RF Diverter 19 .
Then insert the Service Plug 21 to block the water flow.
b. Push the Water Stopper 23 tightly into the Skimmer Seal Ring 22 .
IF YOU PREFER TO LEAVE THE SYSTEM ATTACHED TO THE POOL, please follow the process
below instead.
9
1