Installation Guide

14
Should you encounter any problems, contact Customer Service at [phone] from 8AM to 5PM MST, Monday-Friday.
Extended operating days and hours during peak season requirements.
2
31
31
SFX600/SFX1000
2
Rotor Assembly Parts
Shaft End Cap
Washer
Impeller
Magnet Axle
Rotor Shaft
(This shaft should go through
all the parts and into both
Shaft End Caps)
Washer
Shaft End Cap
SFX1500
STEP 2: Rotor Inspection/Replacement
The Pump 3 is consisted of a Rotor Assembly 27 and its related parts. If the Rotor and/or its parts is/are broken, or the Rotor, even in perfect condition, is not
seated in place between the Volute Cover 28 and Pump Body 31 , the Pump will not function properly.
1. Loosen the Volute Cover Lock Nut 29 or Bolts 30 (depends on the pump model), and remove the Volute Cover 28 .
2. Pull the Rotor Assembly 27 out from the Pump Body 31 .
Inspect the Rotor (see image below) to make sure that the Rotor Shaft, Magnet Axle, Impeller and other parts are intact. If either of them is broken, you can
purchase a new Rotor Assembly at polygroupstore.com without having to replace the whole Pump.
For more details, please see Pool Support – Filtration System Troubleshooting at support.polygroupstore.com
3. Once the inspection or replacement is done, carefully insert the Rotor Assembly 27 back into the Pump Body 31 . The force of the magnet will pull the Rotor
down in place.
4. Align the Volute Cover 28 with the top Shaft End Cap, then tighten with the Volute Cover Lock Nut 29 or Bolts 30 (depends on the pump model).
5. Attach the Rubber Nozzle 2 to the outlet of the Pump Body 31 .
2
3
4
You may need to reach inside the
Canister to free the Pump Motor.
5. Slowly take out the Motor Assembly 3 . Be careful not to lose the Rubber
Nozzle 2 or Canister Gasket 4 .