Installation Guide

OPERATION INSTRUCTIONS
To Use The Leaf Net
1. Extend the telescopic pole to the desired length.
2. Attach the leaf net to the open end of the telescopic pole.
3. Scoop out leaves and other debris from the pool.
Should you encounter any problems, contact Customer Service at [phone] from 8AM to 5PM MST, Monday-Friday.
Extended operating days and hours during peak season requirements.
OWNER′S MANUAL
Directions for Vacuuming With Polygroup
®
Summer Waves Skimmer Pump Models SFX Only.
2. Attach the vacuum head to the open end of the telescopic pole.1. Extend the telescopic pole to its fullest length.
3. Turn on the Skimmer Pump, water will start to flow to the pool through the
return fitting. Keep the pump running throughout the vacuuming process.
4. Hand tighten the water hose cap of the vacuum head.
6. Attach the 1¼” flexible hose to the vacuum head and tighten the hose clamp. 7. Put the vacuum head under water.
5. Loosely attach the hose clamps over the cuffs on the open ends of the flexible hose.
2
Spring
Latch
IMPORTANT NOTE: For vacuuming with other Polygroup
®
Filter Pump Systems; Models: CP2000-C, RP, RX and Sand Filtration Systems; Please follow the
directions on page 4 of this manual.