Installation Guide

Should you encounter any problems, contact Customer Service at [phone] from 8AM to 5PM MST, Monday-Friday.
Extended operating days and hours during peak season requirements.
OWNER′S MANUAL
9. For Summer Waves SFX Skimmer Pump, remove the weir from the canister.
11. Place the open end of the flexible hose up to the return fitting and start to fill the
hose with water. Keep filling the hose until there is no more air inside the hose.
10. Put the vacuum adapter over the strainer and press downward.
A vacuum will be generated that will keep the vacuum adapter in place.
12. Keeping the hose end underwater, slowly slip the end of the hose
through the skimmer opening and attach the end of the hose to
the vacuum adapter's hose connection.
14. A vacuum is now generated from the vacuum head all the way to the filter cartridge.
15. Slowly push the vacuum head across the pool to remove debris. Check the water flow at the return fitting while vacuuming.
16. When the water flow from the return fitting is noticeably reduced, the filter cartridge is likely to be partially clogged. Turn off the pump, remove the filter
cartridge and gently brush/rinse under running water. Replace with a new cartridge if necessary. Repeat the process until the pool is thoroughly cleaned.
IMPORTANT NOTE: For vacuuming with other Polygroup
®
Filter Pump Systems; Models: CP2000-C, RP, RX and Sand Filtration Systems; Please follow the
directions on page 4 of this manual.
13. Hand tighten the hose clamp.
8. Remove the canister top cover of the SFX Series Skimmer pump.
3