Instructions / Assembly

INSTALLATION INSTRUCTIONS
PRELIMINARY STEPS
1. Read all instructions carefully before assembling your SFX Skimmer/Pump system.
2. Identify,familiarize, and check all parts needed for assembly.
3. Follow below illustration and procedures for subsequent installation.
NOTES:
1). Please install the system onto swimming pool before filling it with water.
2). Make sure the pool liner is flat without corrugated spots. Otherwise it may cause damage and potential water
leakage.
3). Visually check the Skimmer canister. It should be close to perpendicular to the ground.
4). Hand-tight the skimmer Seal Ring as tight as possible.
5). The water level in the pool should be between the Max. & Min. lines as indicated on skimmer canister.
6). Do not deliberately force the canister when installed on its right pool position, as it may cause damage to the unit
or the pool.
1
2
3
5
8
7
9
10
11
12
11
10
13
14
15
16
17
18
19
20
21
23
22
24
25
KEY DESCRIPTION
1 MOTOR SEAL NUT
2 MOTOR SEAL GASKET
3 MOTOR
4 MOTOR SEAL
5 TOP COVER
6 WEIR FOAM
7 FILTER CARTRIDGE
8 WEIR
9 SKIMMER CANISTER
10 HOSE O-RING
11 HOSE CLAMP
12 RETURN HOSE
13 ELBOW 90°
14 NUT
15 THRUST WASHER
16 POOL WALL (REF.)
17 RUBBER GASKET
18 POOL WALL FITTING
19 DIVERTER FITTING
20 LOCKING RING
21 RETURN FITTING PLUG
22 SKIMMER SEAL RING
23 WATER STOPPER
24 STRAINER BASKET
25 SEAL RUBBER
THE FILTER CARTRIDGE (6) WILL HOLD 1" DIAMETER
CHLORINE TABLETS.CHECK YOUR CHLORINE LEVELS
TO DETERMINE THE PROPER NUMBER OF TABLETS TO ADD.
4
6
Make sure the key
featureis facing the
correct location.
No obvious gap must
be noticed in this zone.
Seal Rubber
Remove
Seal Ring
Dismount the Skimmer Top Cover and take out the parts.
contained inside.
1
Remove the Seal Ring by unthreading it counterclockwise
Keep Seal Rubber on its proper location.
．
2
Ater placing the threaded intake of the skimmer inside its
corresponding pool hole, screw back the seal ring tightly
on its place.
3
Assemble the wall fitting parts according to the
following schematic.
4
Make sure the two rubber
keyways are properly located
after installation.
Make sure the pool
liner lies on this round
surface, not fall into the
thread slots. It may cause
water seepage.
thread slots
Should you encounter any problems, contact the Customer Service at [phone] from 8 AM to 5 PM Mon. thru Fri.
EST. Extended operating days and hours during peak season requirements.
Should you encounter any problems, contact the Customer Service at [phone] from 8 AM to 5 PM Mon. thru Fri.
EST. Extended operating days and hours during peak season requirements.
43
SFX600 Filter System 70 watts 1.7 amps
1.4 amps
3.1 amps
115 watts
180 watts
SFX1000 Filter System
SFX1500 Filter System
Pump System Wattage Amperage