Instructions / Assembly

Water Level
Max. Level
Min. Level
The Filter Cartridge may
hold 1" diameter chlorine
tablets.Check your chlorine
levels to determine the
proper number of chlorine
tablets to add.
Make sure thehose clamp
is located at the right over the
O-Ring location,to ensure
proper sealing.
hose clamp
O-Ring
canister
Hose end align
with the step
Final assembly must look like the following
schematic.
5
Install weir onto canister.
6
Slip the Top Cover onto the skimmer body.
7
Fill water to a proper limit, plug the outlet,
and enjoy clean pool water.
8
Weir installation
finished.
a) Insert the weir pin
into the proper hole.
b) Push the weir
pin into the hole.
c) Retract the other weir pin, then release to
put it into the proper skimmer hole.
Push here
Push-in
Should you encounter any problems, contact the Customer Service at [phone] from 8 AM to 5 PM Mon. thru Fri.
EST. Extended operating days and hours during peak season requirements.
Should you encounter any problems, contact the Customer Service at [phone] from 8 AM to 5 PM Mon. thru Fri.
EST. Extended operating days and hours during peak season requirements.
65
IMPORTANT: PRESS “RESET” BUTTON ON THE GFCI PLUG TO START BEFORE USING.
IMPORTANT: FILTER CARTRIDGE MUST BE FIRMLY SEATED OVER THE PUMP INTAKE PORT TO
FILTER THE POOL WATER EFFICIENTLY.
NOTE: ONLY FILTER CARTRIDGES WITH A 1-3/4” INCH DIAMETER HOLE WILL WORK PROPERLY.
ANY OTHER SIZE HOLE WILL PREVENT PROPER FILTRATION. THE CARTRIDGE MUST SEAL TIGHTLY
AROUND BOTH ENDS.
A. Plug the GFCI power cord of the filter assembly into a properly grounded receptacle, located
at least 10 feet away from the pool.
B. Press the RESET Button to Start the Pump.
C. Check the return fitting on the inside of the pool for correct flow, it should feel like a solid
stream of water returning to the pool. You can use the return flow as a gauge to determine
when the filter needs cleaning and/or replacement. If you feel a reduction in flow, clean
and/or replace filter.
D. Test water and adjust as needed, see “POOL WATER CARE”, page #5. VERY IMPORTANT – PUMP AND FILTER ALONE
WILL NOT PREVENT ALGAE FROM GROWING IN POOL WATER; THIS CAN ONLY BE DONE BY
MAINTAINING PROPER CHLORINE AND pH LEVELS AT ALL TIMES!
E. The filter may need to be cleaned and/or replaced several times at start up until the correct chlorine and pH levels
are attained. We recommend that you keep at least one spare cartridge on hand at all times. Filter cartridges may
be purchased at the store you purchased your pool from, or ordered from Polygroup.
1 PUMP OPERATION
2 PUMP MOTOR PROTECTION
Press
"RESET"
Button
To Start
Pump
Operation
How to use the GFCI plug:
*Do not connect
to a timer device
IMPORTANT! Your pump is protected by a thermal overload. This device senses the temperature of the pump and
if it is getting too hot, it will open the electric circuit and the pump will stop running until it cools off. It will automati-
cally turn back on when it has cooled down. This is a safety device to help prevent excessive pump damage. If your
pump is automatically turning off, it is because of high pool water temperature and/or low water flow through the
pump. If this happens you need to check water flow through the filter and correct it if needed as this pump uses the
water flow for cooling. You may also want to run the pump at night when the temperature is lower.